【摘要】：針對采用有限元模擬時焊合面不能設置為剛性對稱面的空心型材,其焊合過程不能模擬計算的問題,提出了基于有限元法結合逆向工程技術的焊合面網格重構技術的解決方法,并采用該方法對異形管材分流模擠壓的焊合過程進行了模擬分析.研究結果表明:當擠壓行程為33.1 mm時完成了焊合,焊合溫度范圍477~496℃,焊合室內靜水壓力為169~3 463 MPa,滿足焊合要求;分流橋的焊合角部位所受應力最大,約為205 MPa.模具結構設計合理.
[Abstract]:In order to solve the problem that the welding joint can not be set as a rigid symmetric surface and the welding process can not be simulated by finite element simulation, a method of mesh reconstruction of welding joint based on finite element method and reverse engineering technology is proposed. This method is used to simulate and analyze the welding process of the extrusion of special-shaped pipe shunt die. The results show that when the extrusion stroke is 33.1 mm, the welding temperature range is 477 ~ 496 鈩，

本文編號：2264921