本文選題：CGO硅鋼 + 應變速率　； 參考：《材料熱處理學報》2015年S2期

【摘要】：使用Thermal-Calc計算了3%Si CGO硅鋼的熱力學相圖,使用DIL805A熱膨脹儀測量了實驗鋼的靜態CCT曲線。使用Gleeble 3500進行不同應變速率的熱變形實驗,并使用OM和EBSD研究了應變速率對兩相區變形織構的影響規律。結果表明,在熱力學相圖中,3%Si的電工鋼在1200℃仍處于"奧氏體-鐵素體"兩相區,在750℃時發生"奧氏體-鐵素體"相向"鐵素體-珠光體"相轉變。根據靜態相變點確定3%Si電工鋼的熱軋是兩相區軋制。隨應變速率下降,熱軋退火晶粒的晶粒尺寸不斷變大。應變速率對3%Si CGO兩相區變形產生的織構有影響,{111}110織構組分隨著應變速率的降低先增加后減少。{100}面織構是較強的織構組分。隨應變速率降低,旋轉立方{100}011織構含量較穩定但略有下降。立方{100}001取向晶粒在應變速率較高的試樣中保持了纖維狀分布,在應變速率低的試樣中呈現等軸晶狀,立方{100}001織構在應變速率較高的試樣中含量較高。黃銅型取向晶粒在高應變速率條件下數量極少,在低應變速率條件下數量不多但晶粒尺寸較大。
[Abstract]:The thermodynamic phase diagram of 3%Si CGO silicon steel was calculated by Thermal-Calc and the static CCT curve of experimental steel was measured by DIL805A thermal expansion instrument. Thermal deformation experiments at different strain rates were carried out with Gleeble 3500. The effect of strain rate on deformation texture in two-phase region was studied by OM and EBSD. The results show that the electrical steel with Si in the thermodynamic phase diagram is still in the "austenitic ferrite" two-phase region at 1200 鈩，

本文編號：1986780