本文關鍵詞：不同加熱介質對瀝青軟化點的影響研究　出處：《石油瀝青》2016年06期 　論文類型：期刊論文

  更多相關文章： 瀝青 軟化點 測定條件 加熱介質

【摘要】：分別采用水、乙二醇、甘油做加熱介質,考察了水與乙二醇、甘油與乙二醇兩種體系對瀝青軟化點的影響,并對兩種體系下測得的軟化點的差值及變化規律進行了對比分析。結果表明,軟化點小于80℃的瀝青,使用乙二醇做加熱介質比使用水做加熱介質測得的軟化點高,差值在1℃左右;軟化點大于80℃的瀝青,使用甘油做加熱介質比使用乙二醇做加熱介質測得的軟化點值高,差值在3~5℃之間。
[Abstract]:Using water, ethylene glycol, glycerin as the heating medium, the effects of water and ethylene glycol, ethylene glycol and glycerol two system of softening point influence on asphalt, and two kinds of system measured by the difference and variation of softening point were analyzed. The results show that the softening point is smaller than 80 DEG C asphalt, using ethylene glycol as the softening point of the heating medium than the use of water as the heating medium measured high difference at 1 degrees Celsius; softening point higher than 80 DEG C asphalt, using glycerin as heating medium than using ethylene glycol as the heating medium is measured by the difference in high softening point, 3~5 DEG.

【作者單位】： 中海油(青島)重質油加工工程技術研究中心有限公司;
【分類號】：U414
【正文快照】： 瀝青軟化點是試樣在測定條件下,因受熱而 下墜達25 nun時的溫度。軟化點既是反映瀝青 材料溫度穩定性的一項指標,又是瀝青黏度的一種量度,我國乃至許多國家均把瀝青軟化點作為 一項重要的性能指標m。 2014年施行的瀝青軟化點測定標準GB/T 4507—2014以及交通部標準JTGE20—201，

本文編號：1379601