【摘要】：對Ti-6Al-4V鈦合金真空離子滲氮層的表面完整性進行測試。分析了滲氮溫度、時間等工藝參數對滲層表面粗糙度、殘余應力等的影響規律和機制。研究表明,在650~900℃范圍內,隨著滲氮溫度的升高和滲氮時間的增加,表面粗糙度總體呈現增加的趨勢。其中,滲氮溫度從700℃增加到750℃,滲氮層表面粗糙度大幅增加,殘余應力轉變?yōu)闅堄鄩簯?yīng)力,且應力絕對值顯著增加。證明鈦合金反應擴散滲氮機制啟動溫度在700~750℃范圍內,從而,鈦合金離子滲氮適合的溫度應大于750℃。同時表明,鈦合金滲氮層表面完整性與反應擴散滲氮行為密切相關。在滲氮溫度不高于850℃,滲氮時間不超過16 h的條件下,因滲氮引起的表面粗糙度增加不超過0.3μm,滲層表面殘余壓應力可達-500 MPa。
[Abstract]:The surface integrity of vacuum ion nitriding layer of Ti-6Al-4V titanium alloy was tested. The influence and mechanism of nitriding temperature and time on surface roughness and residual stress of nitriding layer were analyzed. The results show that the surface roughness increases with the increase of nitriding temperature and nitriding time in the range of 650 鈩，

本文編號：2437900