本文選題：煉焦　切入點：多環芳烴　出處：《鋼鐵釩鈦》2017年05期 　論文類型：期刊論文

【摘要】：分別以單煤、配煤為原料,實驗室煉焦?fàn)t模擬制備焦炭,對煉焦過程中產生排放的多環芳烴(PAHs)進行收集、檢測,研究結焦溫度、結焦過程和煤質的黏結性、灰分、水分對煉焦過程中多環芳烴產生排放的影響。結果表明:煉焦溫度為700~920℃時,多環芳烴產生排放量最高;結焦的特點、煤焦油以及熱解產物等因素對煉焦初期多環芳烴的產生排放量影響較大,且低環多環芳烴產生排放較多;多環芳烴產生排放量隨煤的黏結性和灰分的增加而增大,隨水分的增加則先減少后增大。
[Abstract]:Using single coal and blending coal as raw materials, coke was prepared by laboratory coke oven simulation. PAHs emitted from coking process were collected, detected, and coking temperature, adhesion of coking process and coal quality, ash content were studied. The effect of moisture on the emission of PAHs during coking. The results show that when the coking temperature is 700 ~ 920 鈩，

本文編號：1607623