本文選題：礦用排水泵　切入點：固液兩相流　出處：《中國工程機械學報》2016年01期 　論文類型：期刊論文

【摘要】：以應急排水車用排水泵為研究對象,采用數值仿真方法,研究排水泵固液兩相流動特征,分析固體顆粒對水泵的磨損及外特征性能參數影響的規律,提出了有利于流動的模型優化措施.結果表明:葉輪進口后蓋板附近區域、正導葉的凹面以及葉輪葉片進口附近區域的磨損較大;隨著固體顆粒直徑的增大,揚程和效率減小而功率增大,但變化幅度很小,隨著固體顆粒體積含量的增大,其變化趨勢相同但變化幅度較大;通過分析首級葉輪內部流場的不規律流動現象,得到了改善流動狀態的方法.
[Abstract]:Taking the emergency drainage pump as the research object, the characteristics of solid-liquid two-phase flow of the drainage pump are studied by numerical simulation method, and the influence of solid particles on the wear and external characteristic parameters of the pump is analyzed. The results show that the concave surface of the positive guide vane and the impeller blade near the inlet of the impeller have a large wear and tear with the increase of solid particle diameter. The lift and efficiency decrease but the power increases, but the variation range is very small. With the increase of solid particle volume content, the variation trend is the same but the change range is larger. A method to improve the flow state is obtained.
【作者單位】： 大連交通大學機械工程學院;
【基金】：遼寧省自然科學基金(20082150)
【分類號】：U469.6
，

本文編號：1603486