【摘要】：為研究滾筒調速的可行性及調速對傳動系統動態性能的影響,采用MATLAB/Simulink搭建了采煤機截割-牽引耦合機電傳動系統動力學模型.針對截割部過載工況,綜合考慮采煤機可靠運行和高效生產,制定了4種調速降載方案,并提出了通過截割電機電流計算目標切削厚度、依據目標切削厚度選擇調速方案的方法.最后通過仿真對比了各種調速方案下電機和傳動系統的動態響應特性,結果表明:當截割電機過載倍數較小時,采用滾筒調速方案能夠在降低系統負載的同時使采煤生產率不受影響;當過載倍數較大時,采用牽引調速方案可獲得較高的系統可靠性,而采用牽引-滾筒順序調速方案可獲得較高的采煤生產率.
[Abstract]:In order to study the feasibility of the roller speed regulation and the influence of the speed regulation on the dynamic performance of the transmission system, the dynamic model of the cutting-traction-coupled electromechanical transmission system of the coal mining machine is set up by using the MATLAB/ Simulink. In view of the overload working condition of the cutting part, the reliable operation and high-efficiency production of the coal mining machine are considered, four kinds of speed-reducing and load-reducing schemes are set up, and the cutting thickness of the target is calculated by the current of the cutting motor, and the method of selecting the speed-regulating scheme according to the target cutting thickness is proposed. At last, the dynamic response characteristics of the motor and the transmission system under various speed control schemes are compared through simulation. The results show that when the overload multiple of the cutting motor is small, the efficiency of the coal mining can not be affected while the system load is reduced, and when the overload multiple is large, A higher system reliability can be obtained by using a traction speed regulation scheme, and higher mining productivity can be obtained by adopting a traction-roller sequential speed regulation scheme.
【作者單位】： 重慶大學機械傳動國家重點實驗室;
【基金】：國家重點基礎研究發展計劃資助項目(2014CB046304)
【分類號】：TD632.1

【相似文獻】

相關期刊論文 前2條

1 盧燕;礦山節能與風機水泵調速方案淺析[J];中國礦業;1998年04期

2 劉同增;趙輝;;礦井提升機電氣調速方案概述[J];礦山機械;2009年15期

，

本文編號：2510461