剪切力對半固態Sn-Bi合金的組織演變與塑性的影響
發布時間:2019-06-07 16:03
【摘要】:采用機械攪拌半固態鑄造技術制備Sn-62Bi合金,通過XRD、EDS等測試方法探索了不同固相率下剪切力和作用時間對半固態Sn-Bi合金組織和塑性的影響。結果表明:在半固態溫度145℃、攪拌速度為500 r/min和攪拌時間為15 min的工藝條件下,制備出分布均勻、尺寸約30μm塊狀鉍初生相的半固態Sn-62Bi合金,拉伸試驗下的伸長率為39.9%,與在180℃下的合金金屬熔液直接水冷凝固而成的試樣相比,其伸長率提高了283.3%。當攪拌溫度為150℃時,隨著攪拌時間的延長,塊狀初生相Bi相相互摩擦和碰撞破碎,初生相的尺寸減少,分布較均勻,所制備的半固態Sn-62Bi合金的伸長率得到改善。
[Abstract]:Sn-62Bi alloy was prepared by mechanically stirred semi-solid casting. The effects of shear force and action time on the microstructure and plasticity of semi-solid Sn-Bi alloy with different solid phase ratios were investigated by XRD,EDS and other testing methods. The results show that the semi-solid Sn-62Bi alloy with uniform distribution and 30 渭 m bulk bismuth primary phase was prepared under the conditions of semi-solid temperature 145 鈩,
本文編號:2494913
[Abstract]:Sn-62Bi alloy was prepared by mechanically stirred semi-solid casting. The effects of shear force and action time on the microstructure and plasticity of semi-solid Sn-Bi alloy with different solid phase ratios were investigated by XRD,EDS and other testing methods. The results show that the semi-solid Sn-62Bi alloy with uniform distribution and 30 渭 m bulk bismuth primary phase was prepared under the conditions of semi-solid temperature 145 鈩,
本文編號:2494913
本文鏈接:http://sikaile.net/kejilunwen/jinshugongy/2494913.html
最近更新
教材專著