【摘要】：分別采用Sn-40Pb,Sn-3.5Ag和Sn-52In釬料對PZT8壓電陶瓷和銅定子彈性體進行了釬焊試驗,對比分析了3種釬料釬焊定子的振動性能以及釬焊壓力對振動性能的影響.結果表明,采用Sn-52In釬料,配合松香類有機釬劑,在峰值溫度141℃,回流時間116 s,釬焊壓力38.26~114.78 k Pa內的工藝條件下,釬焊形成定子的振動性能最好;在電壓峰峰值80 V的激勵下,釬焊定子的振幅為2.5μm,達到了膠粘定子的振動水平;釬焊接頭的抗剪強度達到6.88 MPa,超過了超聲電機定子對力學性能(≥5 MPa)應用的要求,有望解決膠粘工藝膠接層老化的問題,從而提高超聲電機的使用壽命.
[Abstract]:The brazing tests of PZT8 piezoelectric ceramics and copper stator elastomers were carried out by using Sn-40Pb,Sn-3.5Ag and Sn-52In solders, respectively. The vibration properties of three kinds of brazing stator and the effect of brazing pressure on the vibration properties were compared and analyzed. The results show that the vibration properties of the stator formed by brazing are the best under the conditions of Sn-52In solder, rosin organic flux, peak temperature 141 鈩，

本文編號：2350256