【摘要】：針對A102焊接典型異種接頭的碳遷移現象以及高溫力學性能進行研究,利用由菲克定律推導出的碳擴散理論計算公式對擴散過程進行計算并繪制理論曲線.通過碳的成分分析繪制出實際碳擴散曲線,對熔合線兩側的組織進行觀察.結果表明:理論碳擴散曲線與實際碳擴散曲線基本相同.對于A102焊接的15Cr MoR珠光體耐熱鋼與316奧氏體不銹鋼異質鋼接頭而言,熔合線的不銹鋼焊縫金屬一側出現增碳層,組織主要為碳化物和馬氏體,而15Cr MoR熱影響區一側出現脫碳層,組織主要為鐵素體.蠕變?cè)嚰谌酆暇�脫碳層附近發生斷裂,斷裂方式為韌窩斷裂.
[Abstract]:The carbon migration phenomena and high temperature mechanical properties of typical A102 welded dissimilar joints were studied. The diffusion process was calculated and the theoretical curves were drawn by using the carbon diffusion theory formula derived from Fick's law. The actual carbon diffusion curve was drawn by carbon composition analysis and the microstructure on both sides of the fusion line was observed. The results show that the theoretical carbon diffusion curve is basically the same as the actual carbon diffusion curve. For the joints of 15Cr MoR pearlite heat resistant steel and 316 austenitic stainless steel heterogeneity steel welded by A102, carburized layer appeared on the weld metal side of the weld metal of fusion line, and the microstructure was mainly carbides and martensite, while decarburized layer appeared on the side of 15Cr MoR heat affected zone. The tissue is mainly ferrite. The creep specimen is fractured near the decarburized layer of fusion line, and the fracture mode is dimple fracture.
【作者單位】： 沈陽工業大學材料科學與工程學院;
【基金】：國家自然科學基金資助項目(51301112)
【分類號】：TG407

【參考文獻】

相關期刊論文 前9條

1 鞏建鳴,姜勇,涂善東;碳遷移對鎳基和奧氏體焊條焊接的Cr5Mo異種鋼焊接接頭蠕變破斷壽命的影響[J];材料工程;2003年10期

2 孫開敏;賈寶華;;Q460E-Z35與GS20Mn5V異種鋼焊接[J];電焊機;2012年08期

3 李輝平;趙國群;賀連芳;牟s，

本文編號：2298933