【摘要】：采用自制的CuMnNiCo釬料對氧化物彌散強化(ODS)合金MGH956進行釬焊實驗,分析了釬焊過程中各種組織的形成過程,研究了不同的釬焊溫度對接頭組織和性能的影響。結果表明:在1000~1050℃保溫20min工藝下釬焊MGH956合金,均可獲得良好的釬焊成形效果,釬焊接頭由釬縫中心區的Cu-Mn基固溶體和兩側擴散反應區的Fe-Mn基固溶體組成,并含有三種不同的化合物相。釬焊溫度為1030℃和1050℃時,接頭的室溫拉伸斷裂發生在釬縫中心處,斷口主要呈沿晶脆性斷裂特征。釬焊溫度的提高使沿晶界分布的脆性(Mn,Ni)-Si相減少,有利于改善釬焊接頭強度,釬焊接頭的室溫抗拉強度最高可達到母材強度的75%。
[Abstract]:The brazing experiment of oxide dispersion strengthening (ODS) alloy MGH956 was carried out by using the self-made CuMnNiCo filler metal. The formation process of various microstructure during the brazing process was analyzed, and the effect of different brazing temperature on the microstructure and properties of the joint was studied. The results show that the brazing effect of MGH956 alloy can be obtained by brazing MGH956 alloy at 1000 鈩，

本文編號：2123027