本文選題：冷軋雙相鋼 + 連續退火��； 參考：《鋼鐵研究學報》2015年02期

【摘要】：采用帶鋼連續退火模擬試驗機,研究了連續退火過程中加熱速率、兩相區保溫溫度和過時效溫度對冷軋雙相鋼DP980組織和性能的影響規律。研究結果表明,適當提高加熱速率有利于馬氏體晶粒的細化和帶狀組織的改善,當加熱速率達到45℃/s時可獲得較高的強度和塑性。退火溫度直接決定了硬質第二相的體積分?jǐn)?shù)、分布和形貌,在800℃左右進行退火保溫可以獲得良好的綜合性能,保溫溫度過低或過高都會導致強塑性匹配較差。隨著過時效溫度的降低,強度升高,伸長率下降,試驗鋼退火后加工硬化系數明顯增大。
[Abstract]:The effects of heating rate, two-phase holding temperature and overaging temperature on the microstructure and properties of cold-rolled dual-phase steel DP980 during continuous annealing were studied by using a continuous annealing simulator. The results show that proper increase of heating rate is beneficial to the refinement of martensite grain and the improvement of banded structure. When heating rate reaches 45 鈩，

本文編號：1986990