發布時間：2018-04-10 05:19

  本文選題：熱型連鑄　切入點：表面質量　出處：《中國有色金屬學報》2015年07期

【摘要】：采用自制的熱型連鑄設備制備鋁線材料,研究鑄型溫度和拉鑄速度等工藝參數對材料表面質量、顯微組織及力學性能的影響,通過對最佳工藝條件下制備的鑄錠斷口形貌進行觀察和分析,探討其相關機理。結果表明:當鑄型溫度為675~685℃、拉鑄速度為90~120 mm/min時,可以制備出表面質量較佳的鑄錠;同時,工藝參數會對晶體的擇優取向產生一定影響,當鑄型溫度和拉鑄速度分別為680℃和90 mm/min時,晶體的取向更傾向于沿?100?方向生長,鑄型溫度越高,鑄錠力學性能越優異。當拉鑄速度為90 mm/min時,制備的熱型連鑄鋁線具有最佳的塑性加工能力。相比于普通多晶鋁線,熱型連鑄鋁線具有更好的塑性。
[Abstract]:Aluminum wire materials were prepared by using a self-made hot mold continuous casting equipment. The effects of casting temperature and casting speed on the surface quality, microstructure and mechanical properties of the materials were studied.The fracture morphology of the ingot prepared under the optimum technological conditions was observed and analyzed, and the related mechanism was discussed.The results show that the better surface quality ingot can be prepared when the mold temperature is 675 ~ 685 鈩，

本文編號：1729829