添加鈹對A380鋁合金顯微組織、硬度和拉伸性能的影響(英文)
發布時間:2018-02-24 04:41
本文關鍵詞: 鈹添加 A鋁合金 硬度 拉伸性能 斷口形貌 出處:《Transactions of Nonferrous Metals Society of China》2015年11期 論文類型:期刊論文
【摘要】:研究鈹對A380鋁合金顯微組織、硬度和拉伸性能的影響。采用傳統的鐵模鑄造制備含鈹和不含鈹?shù)腁380合金。采用掃描電鏡和光學顯微鏡研究合金的顯微組織,采用拉伸試驗和硬度測試研究合金的力學性能。研究樣品的斷口形貌,揭示添加鈹對斷裂機制的影響。結果表明,板狀β中間相轉變?yōu)橄鄬?duì)無害的漢字狀Be-Fe相,共晶Si相由片狀相變?yōu)榧?xì)小相。拉伸強度和伸長率分別從207 MPa和3.7%增加至295 MPa和4.7%。此外,隨著鈹含量的增加,A380合金的硬度減小。不含鈹?shù)腁380合金拉伸樣品表現為脆性斷裂,而含鈹合金具有細小韌窩和少量脆性斷面。此外,由于添加鈹細化了析出相,合金的硬度降低。
[Abstract]:The effect of beryllium on the microstructure, hardness and tensile properties of A380 aluminum alloy was studied. The alloy containing and without beryllium was prepared by traditional iron mold casting. The microstructure of the alloy was studied by scanning electron microscope and optical microscope. Tensile test and hardness test were used to study the mechanical properties of the alloy. The fracture morphology of the sample was studied to reveal the effect of adding beryllium on the fracture mechanism. The results showed that the plate 尾 mesophase was transformed into a relatively harmless Chinese character like Be-Fe phase. The tensile strength and elongation of eutectic Si phase changed from flake phase to fine phase. The tensile strength and elongation increased from 207 MPa and 3.7% to 295 MPa and 4.7 respectively. In addition, with the increase of beryllium content, the hardness of A380 alloy decreased, and the tensile sample without beryllium exhibited brittle fracture. The alloy with beryllium has fine dimples and a few brittle sections. In addition, the hardness of the alloy decreases due to the addition of beryllium to refine the precipitated phase.
【作者單位】: School
【基金】:University of Tehran and Graduate University of Advanced Technology for financial and mental support
【分類號】:TG146.21
【參考文獻】
相關期刊論文 前3條
1 S. FARAHANY;A. OURDJINI;M. H. IDRIS;L. T. THAI;;Bi和Sr改性Al-7Si-0.4Mg合金顯微組織的影響(英文)[J];Transactions of Nonferrous Metals Society of China;2011年07期
2 王守仁;馬茹;王英姿;王勇;楊麗穎;;鑄態亞共晶Al-Si合金中初生硅的生長機制(英文)[J];Transactions of Nonferrous Metals Society of China;2012年06期
3 林沖;吳樹森;鐘鼓;萬里;安萍;;超聲振動對高鐵含量過共晶鋁硅合金中富鐵相的影響(英文)[J];Transactions of Nonferrous Metals Society of China;2013年05期
【共引文獻】
相關期刊論文 前10條
1 武曉峰;王U,
本文編號:1528913
本文鏈接:http://sikaile.net/kejilunwen/jinshugongy/1528913.html
最近更新
教材專著