本文關鍵詞： 激光熔覆 復合涂層 時效處理 組織與性能 高溫穩定性　出處：《應用激光》2015年06期 　論文類型：期刊論文

【摘要】：以Ni60-10%hBN(質量分?jǐn)?shù)/%)復合粉末為原料,采用激光熔覆技術在TC4合金表面成功制備出了γ-Ni/TiC/TiB2+CrB-Ni3B/hBN高溫自潤滑耐磨復合涂層。在600℃下分別將該復合涂層保溫10、30、50h,研究不同時長的高溫時效處理后該復合涂層的物相、組織形貌、顯微硬度和摩擦學性能的變化及其機理。結果表明,高溫時效處理前后復合涂層的物相組成基本不變,高溫時效處理50h后的涂層平均顯微硬度由時效處理前的1162HV0.2降為910HV0.2;涂層的摩擦系數及磨損率由時效處理前的0.225和4.85×10-6 mm3/Nm分別升高到0.375和5.35×10-6 mm3/Nm,但相較于基體仍然具有良好的耐磨減摩性能,在600℃下長時間時效處理后,該復合涂層的物相、組織和摩擦學性能都表現出良好的高溫穩定性。
[Abstract]:Using Ni60-10hBN composite powder as raw material, 緯 -Ni / TiC / TiB2 CrB-Ni3B/hBN high temperature self-lubricating and wear resistant composite coatings were successfully prepared on the surface of TC4 alloy by laser cladding technique. The change of microhardness and tribological properties and its mechanism. The results show that the phase composition of the composite coating is basically unchanged before and after high temperature aging treatment. The average microhardness of the coating decreased from 1162HV0.2 to 910HV0.2, and the friction coefficient and wear rate of the coating increased from 0.225 and 4.85 脳 10-6 mm3/Nm to 0.375 and 5.35 脳 10-6 mm / Nm, respectively. Good friction and wear resistance, After aging at 600 鈩，

本文編號：1502766