【摘要】：研究了亞溫淬火工藝中淬火加熱溫度、兩相區淬火溫度、回火溫度等參數對試制的國產9%Ni鋼組織的影響,通過試驗分析確定了實驗室最佳亞溫淬火工藝,即:淬火加熱溫度宜為800℃,兩相區淬火溫度宜為680℃,回火溫度宜為580℃。對亞溫淬火熱處理中容易出現的問題及其與QT處理的不同進行了討論。研究表明,亞溫淬火處理中出現的帶狀組織是由于兩相區淬火加熱保溫時間過長引起元素偏聚造成的,將亞溫淬火保溫時間控制在30 min以?xún)?nèi),可避免帶狀組織出現。亞溫淬火處理可獲得比調質處理更細小的晶粒及更細的組織,逆轉變奧氏體量增多且分布更加彌散均勻。
[Abstract]:The effects of quenching heating temperature, quenching temperature in two-phase zone and tempering temperature on the microstructure of domestic-made 9%Ni steel were studied in this paper. The optimum sub-temperature quenching technology in laboratory was determined by experimental analysis. That is, the quenching temperature is 800 鈩，

本文編號：2448637