【摘要】：采用顯微組織分析、硬度測試、拉伸測試、SEM斷口分析等手段,研究了熱處理工藝對大應變軋制Al-Mg-Si-Cu合金板材顯微組織及力學性能的影響。研究表明:軋制態Al-Mg-Si-Cu合金中軋制面組織呈纖維狀且存在大量殘留相。合金經固溶后顯微組織中殘留相基本溶解,晶粒得到小幅度長大,在時效處理后強化相均勻析出,使得合金得到強化效果。合金經510℃/80 min固溶和195℃/13 h時效熱處理后,測試硬度值為127.1 HV,抗拉強度為410 MPa,伸長率達24.8%,斷口分析為韌性斷裂,合金表現出良好的力學性能。
[Abstract]:The effects of heat treatment on microstructure and mechanical properties of large strain rolled Al-Mg-Si-Cu alloy sheet were studied by means of microstructure analysis, hardness test, tensile test and SEM fracture analysis. The results show that the microstructure of rolled surface in rolled Al-Mg-Si-Cu alloy is fibrous and there is a large number of residual phases. The residual phase in the microstructure of the alloy after solid solution is basically dissolved, and the grains grow up to a small extent. After aging treatment, the strengthening phase is uniformly precipitated, which leads to the strengthening effect of the alloy. After heat treatment at 510 鈩，

本文編號：2442727