【摘要】：研究了Al-4Ti中間合金生產過程中冷卻速度和氟鹽比例對TiAl3相的形貌演變影響規律。結果表明,冷卻速度和氟鹽比例不影響Al-4Ti鑄錠組織中第二相的種類且Al-4Ti合金中不同形貌的TiAl_3相可通過改變鋁熔體冷卻速度而獲得;一般情況下,隨冷卻速度由3.36℃/s降低到0.31℃/s,Al-4Ti中間合金中TiAl3顆粒的形貌由花瓣狀逐漸向塊狀過渡,最后轉變?yōu)榧氶L片狀形貌;特別的,當Al-4Ti中間合金中來自海綿鈦和來自氟鈦酸鉀中的鈦的比例為3∶2時,TiAl_3相的三維形貌對冷卻速度不敏感,都為塊狀。此外,氟鹽的加入與否會在一定程度上影響花瓣狀TiAl_3顆粒的形成。
[Abstract]:The influence of cooling rate and fluorine salt ratio on the morphology evolution of Al-4Ti master alloy was studied. The results show that the cooling rate and the ratio of fluoride to salt do not affect the type of the second phase in Al-4Ti ingot and the TiAl_3 phase with different morphology in Al-4Ti alloy can be obtained by changing the cooling rate of aluminum melt. In general, with the decrease of cooling rate from 3.36 鈩，

本文編號：2414878