【摘要】：在建立基于聲發射技術的裂紋產生與拓展檢測系統的基礎上。以薄鋼板為實驗對象,研究了Lamb波在薄板中傳播的頻散及多模態特性,并結合morlet小波時頻聯合分析方法,提出了一種針對聲發射信號在薄板中傳播時產生的不同模態進行識別的方法。通過提取不同模態波到達同一傳感器的時間差并依據不同模態波對應的波速實現對出現裂紋的位置進行定位。經過實驗研究表明,運用該方法不僅能準確地識別A0、S0模態波并實現對聲發射源進行精確定位。
[Abstract]:Based on acoustic emission technology, the crack generation and expansion detection system is established. The dispersion and multimodal characteristics of Lamb waves propagating in thin plates are studied, and the morlet wavelet time-frequency joint analysis method is combined. This paper presents a method for identifying different modes of acoustic emission signals propagating in thin plates. By extracting the time difference between different mode waves to the same sensor and according to the wave velocity corresponding to different mode waves, the location of the crack is located. The experimental results show that the proposed method can not only accurately identify the A0 / S0 mode waves but also accurately locate the acoustic emission sources.
【作者單位】： 內蒙古科技大學機械工程學院;
【基金】：國家自然科學基金項目(51565047) 內蒙古自治區自然科學基金項目(2015BS0511) 內蒙古自治區高等學校科學研究項目(NJZY154)
【分類號】：TG142.15
，

本文編號：2395519