發布時間：2018-12-18 14:06

【摘要】：采用金相顯微鏡和掃描電鏡研究實驗室模擬薄板坯連鑄連軋(TSCR)工藝試制的高磁感取向硅鋼(Hi-B鋼)組織、織構的演變特征.研究發現實驗室模擬薄板坯連鑄連軋工藝試制的Hi-B鋼熱軋板顯微組織及織構在厚度方向上存在不均勻性.�；灞砻婷撎紝予F素體晶粒明顯粗化,�；蹇棙�(gòu)基本繼承了熱軋板相應的織構類型,僅織構強度不同.一次大壓下率冷軋后,晶粒及其晶界沿軋向被拉長形成鮮明的纖維組織,織構主要為α纖維織構和γ纖維織構,脫碳退火后試樣發生回復和再結晶現象并形成初次晶粒組織,脫碳退火后織構分布較為集中.溫度升高至1000℃時二次再結晶開始,1010℃時鋼中晶粒發生異常長大,高斯織構強度達到61.779.成品磁感為1.915 T,鐵損為1.067 W·kg~(-1).
[Abstract]:The microstructure and texture evolution characteristics of high magnetically oriented silicon steel (Hi-B steel) produced by (TSCR) process were studied by metallographic microscope and scanning electron microscope (SEM). It is found that the microstructure and texture of hot rolled Hi-B steel produced by laboratory simulation of thin slab continuous casting and rolling process are not uniform in thickness direction. The ferrite grain of decarburized layer on the surface of the normal plate is obviously coarser. The texture of the normal plate inherits the corresponding texture type of the hot rolled plate basically, but the texture strength is different. After cold rolling at a high pressure rate, the grain and its grain boundary are elongated along the rolling direction to form distinct fiber structure. The texture is mainly 偽 fiber texture and 緯 fiber texture. After decarbonization annealing, the recovery and recrystallization of the sample occur and the primary grain structure is formed. The texture distribution after decarburization annealing is relatively concentrated. When the temperature rises to 1000 鈩，

本文編號：2385957