本文選題：冷軋無取向硅鋼　切入點：縱向厚度精度　出處：《鋼鐵》2017年04期 　論文類型：期刊論文

【摘要】：針對某冷軋廠無取向硅鋼生產中出現的縱向厚度不符、帶鋼全長縱向厚度高精度命中率偏低的問題,對該廠帶鋼縱向厚度控制的主要環節進行分析。通過工業過程數據分析和理論計算,研究了測厚儀設定參數和冷軋工藝參數對無取向硅鋼縱向厚度精度的影響,并優化相關參數,最終提出提升冷軋無取向硅鋼縱向厚度精度的技術方案。該技術方案應用于現場生產后,消除了生產初期批量出現的硅鋼厚度不符的現象,無取向硅鋼全長縱向厚度偏差5μm以內的比例由方案應用前的85%上升到98%,3μm以內的比例達到90%。
[Abstract]:Aiming at the problem that the longitudinal thickness is not consistent in the production of non-oriented silicon steel and the high precision hit ratio of full-length longitudinal thickness of strip steel is low in a cold rolling plant, The main links of longitudinal thickness control of strip steel in this factory are analyzed. Through the analysis of industrial process data and theoretical calculation, the effects of thickness gauge setting parameters and cold rolling process parameters on the longitudinal thickness accuracy of non-oriented silicon steel are studied. Finally, the technical scheme of improving the longitudinal thickness accuracy of cold rolled non-oriented silicon steel is put forward, which is applied to the field production and eliminates the phenomenon that the thickness of silicon steel does not match in the initial batch production. The ratio of longitudinal thickness deviation of non-oriented silicon steel within 5 渭 m increased from 85% before application to within 98 渭 m.
【作者單位】： 江蘇省(沙鋼)鋼鐵研究院;
【基金】：湖北省自然科學基金資助項目(2014CFB380)
【分類號】：TG337.3

【參考文獻】

相關期刊論文 前10條

1 廖中舉;李U，

本文編號：1603459