本文選題：三葉型回轉窯 + 陶粒�。� 參考：《中國粉體技術》2017年06期

【摘要】：采用三維建模軟件Pro/E建立三葉型回轉窯內部流場三維模型,運用計算流體動力學(CFD)流體仿真分析軟件Fluent,設置邊界條件,選用非預混燃燒模型、離散相模型求解窯內溫度分布情況;通過對一次風速、一次風溫、葉片傾斜角、二次風速、油噴射角度各影響參數進行分析對比。結果表明:當處于50~60 m/s的一次風速,200℃的一次風溫,150 m/s的二次風速,旋流葉片角度為30°左右,噴油角度15°時窯內能得到理想的溫度分布,研究結果為三葉型回轉窯設計制造和工程應用提供參考依據。
[Abstract]:Three-dimensional modeling software Pro-E was used to establish a three-dimensional model of the internal flow field in a three-leaf rotary kiln. The fluid simulation and analysis software Fluent was used to set up boundary conditions, and a non-premixed combustion model was selected. The influence parameters of primary wind speed, primary air temperature, blade inclination angle, secondary wind speed and oil injection angle were analyzed and compared by discrete phase model. The results show that when the primary wind speed of 50 ~ 60 m / s is at 200 鈩，

本文編號：2016813