本文選題：粉煤灰 + 硅鋁浸出　； 參考：《無機鹽工業》2017年06期

【摘要】：研究了采用加堿浸出—混合氧化鈣的方法從粉煤灰中制備硅酸鈣粉體。考察了浸出溫度、浸出時間、堿液濃度、液固比對硅鋁浸出率的影響,實驗結果表明在浸出溫度為90℃、浸出時間為5 h、堿液質量分?jǐn)?shù)為40%、液固質量比為10的條件下硅鋁的浸出效果最佳。同時考察了制備硅酸鈣的影響因素,實驗結果表明在反應溫度為90℃、反應時間為2.5 h、攪拌轉速為30 r/s條件下可制得較純的硅酸鈣制品。對制備的硅酸鈣粉體進行了表征。
[Abstract]:The preparation of calcium silicate powder from fly ash by alkali leaching and mixed calcium oxide was studied. The effects of leaching temperature, leaching time, alkali concentration and liquid-solid ratio on the leaching rate of Si-Al were investigated. The experimental results showed that the leaching temperature was 90 鈩，

本文編號：1825562