【摘要】：為利用溶劑化效應來優化液相沉降聚合聚3,4-乙撐二氧噻吩(PEDOT)的結構和光電性能,將吸附Fe(OTs)3的聚對苯二甲酸乙二醇酯(PET)膜懸于含乙腈的EDOT環己烷溶液中,于60℃原位合成PEDOT涂層。以紫外-可見吸收光譜、X射線光電子能譜分析所合成PEDOT的共軛鏈結構和摻雜度,以四探針測量表面電阻,研究乙腈含量對合成PEDOT結構與性能的影響。當乙腈體積分數為0.05%時,添加的乙腈能抑制短共軛鏈的生成,提高摻雜度,在降低表面電阻的同時,改善透光率。乙腈體積分數在0.24%以內時,PEDOT的導電性隨乙腈體積分數的上升而增加。當乙腈體積分數超過0.7%時,PEDOT中短共軛鏈數目增加,光電性能下降。當乙腈體積分數為8%時,由于吸附的Fe(OTs)_3溶解太快,無法在PET表面合成導電PEDOT膜。乙腈體積分數為0.24%時,獲得的PEDOT膜的表面電阻可達174Ω,透光率80%,粘附力為5B級。
[Abstract]:In order to optimize the structure and optoelectronic properties of poly (3o 4-ethylenedioxythiophene) (PEDOT) prepared by liquid-phase deposition polymerization by solvent effect, the (PET) film adsorbed on Fe (OTs) _ 3 was suspended in EDOT cyclohexane solution containing acetonitrile, and the PEDOT coating was synthesized in situ at 60 鈩，

本文編號：2145205