本文關鍵詞：液晶可變相位延遲器相位延遲的精確定標　出處：《光電子·激光》2016年08期 　論文類型：期刊論文

  更多相關文章： 液晶可變相位延遲器(LCVR) 相位延遲 初始相位延遲定標 最小二乘法

【摘要】：為了能夠利用液晶可變相位延遲器(LCVR,liquid crystal variable retarder)對光波的相位延遲進行準確測量,提出一種基于Stokes參量測量光強法和最小二乘法的LCVR對光波相位延遲的精確定標方法。從理論分析光波經LCVR后影響相位延遲變化的因素,采用基于Stokes參量測量的光強法分別對波長為405、532、632和641nm入射光相位延遲隨電壓的變化進行測量,并實驗驗證歸一化后的相位延遲變化只與驅動電壓有關;基于最小二乘法對不同波長的初始相位延遲量進行定標研究,導出不同波長入射光經LCVR后初始相位延遲量定標方程,用671nm波長的激光對定標方程進行了驗證,經定標方程求解的671nm波長的初始相位延遲量與實際值偏差為1.4nm,且任一驅動電壓下,相位延遲量的實際測量值與公式定標計算值最大相對誤差為0.18%。最后,通過與其他定標方法的比較,進一步說明采用本文方法定標的精確性和可靠性。
[Abstract]:In order to measure the phase delay of light wave accurately, the liquid crystal variable phase delay device LCVRliquid crystal variable retarder can be used. An accurate calibration method of optical wave phase delay by LCVR based on Stokes parameter measurement method and least square method is proposed. The factors influencing the phase delay of light wave after LCVR are analyzed theoretically. The light intensity method based on Stokes parameter measurement is used to measure the phase delay of incident light at wavelength of 405,532,632 nm and 641 nm respectively. The results show that the normalized phase delay is only related to the driving voltage. Based on the least square method, the initial phase delay of different wavelength is calibrated, and the initial phase delay calibration equation of different wavelength incident light after LCVR is derived. The calibration equation is verified by using the laser at 671nm wavelength. The initial phase delay of 671nm wavelength is 1.4 nm and the deviation between the initial phase delay and the actual value is 1.4 nm under any driving voltage. The maximum relative error between the actual measured value of phase delay and the calculated value of formula calibration is 0.18. Finally, by comparing with other calibration methods, the accuracy and reliability of calibration using this method are further explained.
【作者單位】： 中北大學電子測試技術重點實驗室山西省光電信息與儀器工程技術研究中心;中北大學理學院;
【基金】：國家自然科學基金儀器專項基金(61127015) 國際科技合作項目(2013DFR10150) 山西省青年科技研究基金(2014021012)資助項目
【分類號】：O753.2
【正文快照】： 1引言向列型液晶可變相位延遲器(LCVR)是根據具有單軸雙折射特性的各向異性液晶分子易受電場、磁場的影響而發生偏轉,從而使得入射光波的相位受到調制而制成的偏振光學器件[1,2]。LCVR與彈光、電光等其他相位延遲器件[3,4]相比,具有調制電壓低、入射角度對延遲效果影響不大[5]

【相似文獻】

相關期刊論文 前2條

1 云茂金,李國華;晶體相位延遲測量的λ/4波片法及理論研究[J];激光技術;2001年05期

2 ;[J];;年期

相關會議論文 前2條

1 杝柏郡;呍，

本文編號：1365654