【摘要】：存儲規劃是倉儲系統中的一部分，是實現倉儲管理的關鍵環節，是倉儲管理部門為了充分利用所具有的倉儲資源提供高效的倉儲服務所進行的計劃、組織、控制和協調的重要組成部分。 某煙草工業企業的卷煙成品物流倉庫即DZ庫在響應國家煙草專賣局“一號工程”下，采用條形碼(BARCODE)、射頻(FRID)等技術，有效地提高了出庫效率的，實現了數字化倉儲管理，物流體系和物流信息化系統已形成了初步規模。但其中存儲環節依舊需要較高的人工干預，尚有較大的優化空間。主要集中缺乏合理有效的庫內存儲區域的規劃和庫內成品煙流轉策略。 本文以DZ庫的存儲區域的規劃為核心內容展開研究。對目前我國企業應用存儲規劃的幾種典型經驗及當前流行的存儲規劃方法等進行了綜合性的闡述。根據DZ庫存儲方面的現狀進行全面系統的分析，從DZ庫的設備、品規存儲布局、庫內流轉狀況各方面進行梳理，找出問題的制約瓶頸。通過ABC/FMR方法確定成品煙品規等級劃分，根據等比概率模型將已經得到確定的成品卷煙品規分配到不同樓層，，應用等比概率模型與轉儲優化模型確定每層分配品規確定量值與種類，并以DZ庫一定周期的實際數據驗證模型，在選取衡量指標后，通過flexsim仿真對該煙草工業企業卷煙成品庫存儲規劃前后進行對比。 結果表明本模型可解決DZ庫存儲區域的規劃問題，有效提升存儲設備使用效率，合理調配DZ庫各樓層間存儲平衡，通過調整存儲布局，方便出庫品規選取作業，減少出庫的搬運距離，尤其是關聯品規的設定、降低迂回運輸，縮短DZ庫出庫響應時間，完成對DZ樓層庫的存儲規劃的既定目標。
[Abstract]:Storage planning is a part of warehousing system, is the key link to realize warehousing management, is the plan and organization of warehousing management department in order to make full use of the warehousing resources to provide efficient warehousing services. An important part of control and coordination. In response to the "No. 1 Project" of the State Tobacco Monopoly Bureau, the cigarette finished product logistics warehouse of a tobacco industry enterprise adopts bar code (BARCODE), radio frequency (FRID) technology, which effectively improves the efficiency of the cigarette finished product logistics warehouse, that is, the DZ library, in response to the "No. 1 Project" of the State Tobacco Monopoly Bureau. The realization of digital warehousing management, logistics system and logistics information system has formed a preliminary scale. However, the storage link still needs high manual intervention, and there is still a lot of room for optimization. It mainly focuses on the lack of reasonable and effective planning of the storage area and the circulation strategy of finished products in the warehouse. In this paper, the planning of the storage area of DZ library is studied. Several typical experiences of enterprise application storage planning in China and the popular storage planning methods are described in this paper. According to the present situation of DZ library storage, this paper makes a comprehensive and systematic analysis, combs the equipment of DZ library, the layout of product specification storage and the circulation situation in the library, and finds out the bottleneck of the problem. The grade classification of finished cigarette gauge is determined by ABC/FMR method, and the determined finished cigarette gauge is assigned to different floors according to the equal ratio probability model. The equal ratio probability model and dump optimization model are used to determine the value and type of each layer distribution rule, and the model is verified by the actual data of a certain period of DZ library. after selecting the measurement index, The storage planning of cigarette products warehouse in this tobacco industry enterprise was compared by flexsim simulation before and after storage planning. The results show that the model can solve the planning problem of DZ inventory area, effectively improve the efficiency of storage equipment, reasonably deploy the storage balance among the floors of DZ library, and facilitate the selection of storage rules by adjusting the storage layout. Reduce the handling distance, especially the setting of related rules, reduce roundabout transportation, shorten the response time of DZ warehouse, and complete the established goal of storage planning for DZ floor library.
【學位授予單位】：北京物資學院
【學位級別】：碩士
【學位授予年份】：2013
【分類號】：F426.89;F259.22;F224

【參考文獻】

相關期刊論文 前10條

1 李昌隆;程鵬;陳曉波;柴旭東;;按區域懲罰劃分的并行多目標遺傳算法[J];北京航空航天大學學報;2005年11期

2 左春榮;張志萍;;基于Petri網的第三方物流配送系統的建模研究[J];商業研究;2008年04期

3 李楠;任章璐;林瑩;;ABC分類法下存貨周轉率計算公式的修正[J];財會月刊;2011年08期

4 張川;劉保政;戢守峰;張翠華;;基于隨機補貨間隔和非線性變質率的易腐商品補貨模型[J];東北大學學報(自然科學版);2012年01期

5 計明軍;靳志宏;;基于可控提前期的庫存優化模型[J];大連海事大學學報;2011年01期

6 王蓀馨;;基于遺傳算法的作業車間設備布局優化方法[J];工業工程;2009年03期

7 李詩珍;;揀貨方式、存儲策略與路徑策略協同研究[J];工業工程;2011年02期

8 汪家常,韓偉偉;戰略預算管理問題研究[J];管理世界;2002年05期

9 李華;劉志學;汪小京;鄭長征;;考慮運輸能力約束的VMI補貨發貨動態批量研究[J];工業工程與管理;2011年01期

10 季德雨;田豐;王傳云;;融合WSN和RFID的智能入庫管理系統設計[J];沈陽航空航天大學學報;2011年02期

相關碩士學位論文 前2條

1 但京;基于遺傳算法的鋼材物流園區規劃研究[D];武漢理工大學;2011年

2 胡建國;關于配送中心作業流程中若干環節的研究[D];長沙理工大學;2004年

本文編號：2482717