發布時間：2019-02-13 16:08

【摘要】：針對傳統密封方法在澆注光彈性模型時容易導致澆注液泄漏和模型尺寸誤差大的問題,提出一種新的硅橡膠陰模密封方法。該方法采用與陰模相同的密封材料和固化工藝進行密封。齒輪光彈性模型的澆注實例表明,相同材料和固化工藝的采用使密封層與陰模成為一個整體,在不同溫度和氣壓環境下均不會出現分離,有效避免了澆注液的滲漏;密封層厚度為陰模壁體最薄處的0.5~1.5倍,緊固力小,使模型各方向收縮膨脹均勻,降低了模型的附加變形。采用新密封方法澆注得到的光彈性模型無缺料現象,制造的齒輪內圓直徑和高度的最大誤差均小于2%,模型尺寸精度滿足光彈性試驗要求。
[Abstract]:A new sealing method of silicone rubber negative die is proposed to solve the problem that the traditional sealing method can easily lead to the leakage of pouring fluid and the large size error of the model when casting photoelastic model. This method uses the same sealing material and curing process as the negative die. The example of the pinion photoelastic model shows that the same material and curing technology make the sealing layer and the negative die as a whole and will not be separated under different temperature and pressure environment, which effectively avoids the leakage of the pouring liquid. The thickness of the sealing layer is 0.5 ~ 1.5 times that of the thinnest part of the die, and the fastening force is small, which makes the shrinkage and expansion of the model even and reduces the additional deformation of the model. The new sealing method is used to cast the photoelastic model. The maximum errors of the diameter and height of the inner circle are less than 2, and the precision of the model can meet the requirements of photoelastic test.
【作者單位】： 中國航空動力機械研究所;航空發動機振動技術航空科技重點實驗室;
【基金】：航空科學基金項目(20122108002)
【分類號】：TQ333.93;TB42

【相似文獻】

相關期刊論文 前2條

1 許華蕓;劉寧;;不同密度的泡沫塑料制作陰模質量的比較[J];實用臨床醫學;2008年07期

2 ;[J];;年期

，

本文編號：2421714