本文選題：雙相磷酸鈣陶瓷 + 多孔�。� 參考：《華南理工大學》2015年碩士論文

【摘要】：本文針對目前冷凍干燥法制備的定向多孔磷酸鈣陶瓷材料在孔隙寬度和力學性能上存在的不足,采用冰晶模板-冷凍干燥法制備了具有定向多孔結構的雙相磷酸鈣(BCP)陶瓷支架材料。通過優化燒成制度;加入Na Cl等添加劑調控孔結構;灌注卵磷脂改性PLGA溶液和添加磷酸鹽玻璃(PG)燒結助劑兩種方法對支架進行增強,并評價增強支架的細胞行為,從而得到了結構和性能較好的多孔孔雙相磷酸鈣陶瓷支架。通過將中位徑為7.554μm的β-TCP粉末和中位徑為12.024μm的HA粉末在去離子水中機械混合制備了較為均勻的BCP料漿,灌注后采用冰晶模板-冷凍干燥法制備了具有定向多孔結構的雙相磷酸鈣陶瓷材料。通過探究燒成溫度(1000~1300°C)和保溫時間(2、4、6 h)對支架物相組成、多孔結構以及抗壓強度的影響,優化了支架的燒成制度。通過在制備料漿時添加Na Cl溶液顯著增大了定向多孔BCP支架垂直于冷凍方向上的孔隙尺寸。當Na Cl的添加量為10 wt.%時,支架垂直于冷凍方向上的平均孔徑可達111.27μm,支架的抗壓強度也得到顯著提高。實驗還發現,通過在料漿中加入聚乙二醇(PEG)、聚乙烯吡咯烷酮(PVP)并不能促進冰晶尺寸的增大從而得到較大孔徑的多孔支架。采用添加磷酸鹽生物玻璃(PG)作燒結助劑和灌注卵磷脂改性的PLGA溶液復合的兩種增強方法,通過探究PG的添加量和PLGA溶液的灌注濃度,制備得到了具有良好結構和性能的多孔支架材料。當PG添加量為17.5 wt.%時,支架的抗壓強度可達5.7 MPa,孔隙率為55.9%;當PLGA溶液的復合濃度為7.5%時,顯著提高了支架的韌性,形變量和抗壓強度分別可以達到40%和7.8 MPa,孔隙率為57.3%。同時,對增強支架的體外降解性能和細胞生物學行為的研究結果表明PG/BCP和PLGA/BCP多孔支架材料在PBS中浸泡28天后失重率都較低(10%),沒有發生崩解,能保持原有的結構,兩種材料都具有良好的生物相容性,細胞在材料上都黏附良好,且具有較好的增殖能力,有望經后續改進后應用于骨缺損修復領域。
[Abstract]:In this paper, the defects in pore width and mechanical properties of directional porous calcium phosphate ceramics prepared by freeze-drying method are pointed out. A biphasic calcium phosphate (BCP) ceramic scaffold with directional porous structure was prepared by freezing drying method. The scaffold was enhanced by optimizing sintering system, adding NaCl and other additives to regulate pore structure, injecting lecithin modified PLGA solution and adding phosphate glass (PG) sintering promoter to enhance the scaffold, and to evaluate the cell behavior of the enhanced scaffold. Thus, porous dual phase calcium phosphate ceramic scaffolds with better structure and performance were obtained. By mixing 尾 -TCP powder with a median diameter of 7.554 渭 m and HA powder with a median diameter of 12.024 渭 m in deionized water, a uniform BCP slurry was prepared. After perfusion, biphasic calcium phosphate ceramics with directional porous structure were prepared by freezing drying method. The sintering process of the scaffold was optimized by investigating the effects of sintering temperature (1000 ~ 1300 擄C) and holding time (2 ~ 4 ~ 6 h) on the phase composition, porous structure and compressive strength of the scaffold. The pore size perpendicular to the freezing direction of the directional porous BCP scaffold was significantly increased by adding NaCl solution in the preparation of slurry. The average pore diameter perpendicular to the freezing direction can reach 111.27 渭 m when the NaCl content is 10 wt.%, and the compressive strength of the scaffold is also significantly increased. It was also found that polyvinylpyrrolidone (PVP) could not promote the increase of ice crystal size by adding polyethylene glycol (PEG) to the slurry to obtain porous scaffolds with large pore size. By adding phosphate bioglass (PG) as sintering promoter and by adding lecithin modified PLGA solution, two reinforcement methods were used to study the dosage of PG and the concentration of PLGA solution. Porous scaffolds with good structure and properties were prepared. When PG was added 17.5 wt.%, the compressive strength and porosity of the scaffold reached 5.7 MPA and 55.90.When the composite concentration of PLGA solution was 7.5, the toughness of the scaffold was significantly improved, the shape variable and compressive strength were 40% and 7.8 MPA, respectively, and the porosity was 57.3 MPA. At the same time, the results of in vitro degradation and cell biological behavior of enhanced scaffolds showed that the weight loss rate of PG- / BCP and PLGA / BCP porous scaffolds after 28 days of immersion in PBS was lower (10%), no disintegration occurred, and the original structure could be maintained. The two materials have good biocompatibility, good adhesion on the material, and good proliferative ability. They are expected to be used in the field of bone defect repair after further improvement.
【學位授予單位】：華南理工大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：R318.08

【參考文獻】

相關期刊論文 前7條

1 劉斌;董寅生;王玲;蘇靜;姚義俊;林萍華;;復合磷酸鹽多孔生物陶瓷的制備及性能[J];武漢理工大學學報;2011年09期

2 羅德福;趙康;陳永楠;馬楚凡;吳少旭;;內部連接的球形多孔羥基磷灰石支架的制備[J];硅酸鹽學報;2007年03期

3 包崇云;張興棟;;磷酸鈣生物材料固有骨誘導性的研究現狀與展望[J];生物醫學工程學雜志;2006年02期

4 徐建強,胡蘊玉,張超,熊卓,彥永年,呂榮;大段仿生活性人工骨修復兔長骨缺損的實驗研究[J];中華創傷骨科雜志;2005年09期

5 戴紅蓮,李世普,賀建華,閆玉華;碳纖維增強α-TCP/TTCP骨水泥的研究[J];無機材料學報;2004年05期

6 蔡舒,周彩樓,李金有,葛志平;雙相磷酸鈣多孔陶瓷的制備[J];陶瓷學報;2001年03期

7 董子明,楊曉,羅彥菊;鈦合金根管內骨種植體治療前牙根折76例報道[J];口腔頜面修復學雜志;2000年01期

相關博士學位論文 前1條

1 何福坡;具有定向孔結構的磷酸鈣骨水泥復合支架的構建和性能[D];華南理工大學;2013年

相關碩士學位論文 前7條

1 楊森;TiC-Al_2O_3復相陶瓷增強Fe基復合材料的制備及性能研究[D];長安大學;2013年

2 杜建聰;高孔隙率Al_2O_3多孔陶瓷的冷凍注模成型及微觀組織與性能研究[D];哈爾濱工業大學;2010年

3 朱志軍;雙相磷酸鈣/硫酸鈣/絲素蛋白骨水泥性能研究[D];蘇州大學;2010年

4 王新娟;冷凍干燥法制備羥基磷灰石多孔支架[D];西安理工大學;2008年

5 朱婧彬;靜電紡絲法制備聚乳酸及改性聚乳酸納米纖維[D];山東大學;2007年

6 劉同軍;β-TCP/HAP復合生物陶瓷的制備[D];天津大學;2006年

7 傅小妮;聚氨酯發泡法制備多孔HA/β-TCP生物陶瓷及其性能研究[D];四川大學;2004年

，

本文編號：2110840