王曲電廠600MW機組脫硝系統運行特性及其控制分析
本文選題:鍋爐 切入點:SCR 出處:《華北電力大學》2017年碩士論文 論文類型:學位論文
【摘要】:火電廠是大氣污染物氮氧化物的主要排放源。目前電廠鍋爐都配置了煙氣脫硝系統,SCR脫硝技術得到了廣泛應用,但是由于SCR脫硝過程及系統復雜,電廠脫硝系統自動控制投入率還較低,很多電廠的脫硝系統處于手動控制狀態,脫硝系統的自動控制水平還有待進一步提高。以王曲電廠600MW鍋爐機組SCR脫硝系統為研究對象,對其SCR煙氣脫硝系統的工作原理、工藝流程、系統構成等進行了分析。以電廠機組運行過程中DCS記錄的歷史數據為基礎,對不同運行工況下SCR系統大量的運行數據進行分析與處理,結合SCR脫硝反應機理分析,得到了SCR系統的動態特性和靜態特性。分析了負荷、噴氨量等參數變化時其他相關參數的動態變化規律;分析了脫硝效率隨鍋爐負荷、氨氮摩爾比、氧量等因素的靜態變化規律。并對王曲電廠SCR控制系統構成、原理及控制邏輯、控制方式進行了設計分析,基于所整理的機組運行數據,通過遞推最小二乘法,對系統進行辨識,得到了該機組典型工況下,SCR出口NOx濃度與噴氨量的傳遞函數模型。仿真結果表明:模型的輸出與實際輸出的誤差在允許范圍內。并對模型進行了驗證與分析,可為王曲電廠SCR自動控制系統的設計提供參考。
[Abstract]:Thermal power plant is the main emission source of nitrogen oxide. At present, the flue gas denitrification system / SCR denitrification technology has been widely used in power plant boilers, but because of the complex process and system of SCR denitrification, The input rate of automatic control of power plant denitrification system is still low, and many power plant denitrification systems are in manual control state, and the automatic control level of denitrification system needs to be further improved. The SCR denitrification system of 600MW boiler unit in Wangqu Power Plant is taken as the research object. The working principle, process flow and system constitution of the SCR flue gas denitrification system are analyzed. Based on the historical data recorded by DCS during the operation of the power plant unit, The dynamic and static characteristics of SCR system are obtained by analyzing the operation data of SCR system under different operating conditions, combined with the analysis of SCR denitrification reaction mechanism, and the load is analyzed. The dynamic change law of other related parameters when ammonia injection rate is changed, the static variation law of denitrification efficiency with boiler load, ammonia nitrogen molar ratio, oxygen quantity and other factors are analyzed. The constitution, principle and control logic of SCR control system in Wangqu Power Plant are analyzed. The control method is designed and analyzed. The system is identified by recursive least square method based on the running data of the unit. The transfer function model of NOx concentration and ammonia injection at the outlet of the unit under typical operating conditions is obtained. The simulation results show that the error between the output of the model and the actual output is within the allowable range, and the model is verified and analyzed. It can provide reference for the design of SCR automatic control system in Wangqu Power Plant.
【學位授予單位】:華北電力大學
【學位級別】:碩士
【學位授予年份】:2017
【分類號】:TM621;X773
【參考文獻】
相關期刊論文 前10條
1 周衛青;吳華成;王斌;任學剛;;燃煤電廠SCR催化劑活性跟蹤檢測及失活原因分析[J];華北電力技術;2015年08期
2 孫維菊;邵長暖;;1000MW超超臨界機組SCR脫硝系統運行中存在問題及解決措施[J];山東工業技術;2015年02期
3 李恩家;顧楊楊;衣賀昌;鐘祚群;于德亭;;燃煤電廠鍋爐SCR脫硝系統調試技術研究[J];電站系統工程;2014年01期
4 張乘勝;張晉波;;SCR脫硝系統經濟效率探索[J];能源與節能;2013年09期
5 李峰;王立;高富春;;SCR煙氣脫硝自動控制系統及其在國華三河電廠的應用[J];熱力發電;2009年05期
6 馮立波;羅鐘高;葛春亮;;火電廠SCR煙氣脫硝工藝系統設計[J];能源工程;2009年01期
7 趙毅;朱洪濤;安曉玲;蘇蓬;;燃煤電廠SCR煙氣脫硝技術的研究[J];電力環境保護;2009年01期
8 李慶;黃先騰;彭日亮;;燃煤發電廠SCR煙氣脫硝系統的設計選型[J];華北電力技術;2008年06期
9 張強;張西濤;;燃煤電站實施SCR脫硝技術的關鍵工藝選擇[J];熱力發電;2007年04期
10 楊冬;徐鴻;;SCR煙氣脫硝技術及其在燃煤電廠的應用[J];電力環境保護;2007年01期
相關會議論文 前2條
1 彭獻永;劉貴喜;王春麗;孫思敬;易凡;;大型火電機組SCR煙氣脫硝過程的控制策略分析和優化方案[A];2016燃煤電廠超低排放形勢下SCR(SNCR)脫硝系統運行管理及氨逃逸與空預器堵塞技術交流研討會論文集[C];2016年
2 孫東鋒;黃啟東;;1000MW機組煙氣超低排放改造脫硝系統控制策略改進及探討[A];燃煤電廠“超低排放”新技術交流研討會論文集[C];2014年
相關碩士學位論文 前5條
1 張淼;XX電廠鍋爐煙氣脫硝工藝技術方案優選研究[D];吉林大學;2016年
2 王濤;空氣預熱器SCR脫硝適應性及催化劑的試驗研究[D];山東大學;2015年
3 陳靜;烏魯木齊市葦湖梁電廠煙氣脫硝方案的技術經濟分析[D];新疆農業大學;2013年
4 韓磊磊;滄東電廠四號機組脫硝工藝選擇及運行分析[D];華北電力大學;2013年
5 湯元強;燃煤電廠SCR煙氣脫硝系統優化與飛灰顆粒運動的研究[D];上海交通大學;2012年
,本文編號:1635371
本文鏈接:http://sikaile.net/shengtaihuanjingbaohulunwen/1635371.html