發布時間：2018-12-11 20:45

【摘要】：從降低生產成本的角度考慮,嘗試在真空爐中采用一步燒結法制備梯度結構硬質合金。實驗研究了燒結工藝參數對合金顯微結構及密度的影響,結果表明:梯度結構硬質合金樣品表層的WC晶粒大于富鈷層及芯部區域;隨著燒結溫度升高,樣品表層WC晶粒變粗,梯度結構硬質合金密度先增加后降低;延長燒結時間會顯著增加樣品表層兩相區的厚度。本實驗所制備的硬質合金梯度層厚度可達1 168μm,燒結時間越長,樣品密度越低。
[Abstract]:In order to reduce the production cost, the gradient cemented carbide was prepared by one step sintering in vacuum furnace. The effect of sintering process parameters on the microstructure and density of the alloy was studied experimentally. The results show that the WC grains in the surface layer of the graded cemented carbide are larger than those in the cobalt-rich layer and the core area. With the increase of sintering temperature, the grain size of WC in the surface layer of the sample becomes coarser, the density of the gradient cemented carbide increases first and then decreases, and the thickness of the two-phase region of the surface layer increases significantly when the sintering time is prolonged. The gradient layer thickness of cemented carbide prepared in this experiment can reach 1 168 渭 m. The longer the sintering time is, the lower the sample density is.
【作者單位】： 中南大學粉末冶金研究院;
【分類號】：TG135.5

【相似文獻】

相關期刊論文 前2條

1 張桂香;趙玉剛;趙東標;張萍萍;;燒結法與霧化法制備磁性磨料的形貌及研磨性能[J];機械工程材料;2012年03期

2 ;[J];;年期

，

本文編號：2373192