發布時間：2019-07-20 20:07

【摘要】：針對某手機裝配線產品產能不達標的問題,提出了利用Witness仿真技術建立裝配線的仿真模型進行優化研究的方案。首先,利用秒表測時法收集裝配線各工位操作時間,并利用Minitab統計軟件對收集到的數據進行擬合分析,獲得最優擬合參數,同時對裝配線建立仿真模型,找出瓶頸工位;然后利用Flexible Line Balancing軟件、雙手作業分析、防錯法對瓶頸工位進行改善,從而減少了工時浪費,降低生產成本,提高產線生產效率。最后再利用Witness軟件對優化方案進行檢驗,確保改善效果真實有效。
[Abstract]:In order to solve the problem that the production capacity of a mobile phone assembly line is not up to standard, a scheme is proposed to establish the simulation model of the assembly line by using Witness simulation technology to optimize the research. Firstly, the operating time of each station in the assembly line is collected by the second meter time measurement method, and the optimal fitting parameters are obtained by using Minitab statistical software to fit and analyze the collected data, and at the same time, the simulation model of the assembly line is established to find out the bottleneck station, and then the bottleneck station is improved by using Flexible Line Balancing software, two-hand operation analysis and error prevention method, thus reducing the waste of working hours, reducing the production cost and improving the production efficiency of the production line. Finally, Witness software is used to test the optimization scheme to ensure that the improvement effect is true and effective.
【作者單位】： 中國礦業大學礦業工程學院;
【分類號】：TN929.53

【相似文獻】

相關碩士學位論文 前2條

1 郭湛皓;基于精益生產的手機裝配線平衡研究與應用[D];南昌大學;2012年

2 羅楊;電視機裝配線的仿真與工作研究[D];西華大學;2010年

，

本文編號：2516889