本文關鍵詞： 爆炸力學 爆炸效應 內爆炸 典型空腔　出處：《爆炸與沖擊》2016年03期 　論文類型：期刊論文

【摘要】：為了獲得在典型空腔內發生爆炸后,結構壁面上爆炸載荷的分布規律和空腔結構的破壞形式,以國防工事和人防工事的等級設計規范為依據,設計了長方體單腔室空腔模型,并對該模型進行了藥量逐漸遞增直至可使結構破壞的內爆炸實驗。用壓力傳感器和加速度傳感器分別記錄了單腔室壁面上爆炸載荷的壓力時程曲線和結構壁面振動的加速度時程曲線,分析了壁面上爆炸載荷的分布規律以及模型結構的破壞形式,并將首個峰值的實測數據與理論計算和數值模擬結果進行了對比,探討了3種研究方法產生誤差的原因。
[Abstract]:In order to obtain the distribution law of explosion load on the wall of the structure and the failure form of the cavity structure after the explosion occurred in the typical cavity, a cuboid single chamber cavity model was designed based on the grade design code of national defense and civil air defense. An internal explosion experiment was carried out on the model, in which the charge was gradually increasing until the structure could be destroyed. The pressure time history curve of explosion load on the wall of a single chamber and the wall vibration of the structure were recorded by pressure sensor and acceleration sensor, respectively. Dynamic acceleration time history curve, The distribution law of explosion load on the wall and the failure form of the model structure are analyzed. The experimental data of the first peak value are compared with the theoretical calculation and numerical simulation results, and the causes of the errors in the three research methods are discussed.
【作者單位】： 華北科技學院安全工程學院礦井災害防治重點實驗室;
【基金】：華北科技學院創新團隊項目(3142015021,3142014124) 爆炸科學與技術國家重點實驗室開放基金項目(KFJJ15-15M)
【分類號】：O381

【相似文獻】

相關期刊論文 前4條

1 宋衛東;吳開騰;寧建國;;機庫內爆炸效應的數值模擬研究[J];兵工學報;2007年11期

2 王仲琦,寧建國,趙衡陽,惲壽榕;擋墻對遠場爆炸效應影響的數值模擬研究[J];爆炸與沖擊;2000年01期

3 鄔玉斌;;地下結構偶然性內爆炸效應研究[J];國際地震動態;2012年03期

4 ;[J];;年期

，

本文編號：1504434