利用鞍鋼燒結灰渣開發尾砂膠凝材料正交試驗與決策
發布時間：2019-06-12 15:22
【摘要】：燒結脫硫灰渣是焦化廠生產煉鋼焦煤排放的廢棄物。由于脫硫灰渣含有游離氧化鈣和亞硫酸鈣等不穩定的礦物成分,導致燒結脫硫灰渣資源利用面臨困難。針對鞍鋼礦山全尾砂無廢充填法開采,以礦渣微粉和燒結脫硫灰渣作為主要材料,熟料和硫酸鹽為復合激發劑,對鞍鋼礦山全尾砂充填膠凝材料進行開發。首先開展充填膠凝材料配比的正交試驗;然后,在極差分析的基礎上,建立神經網絡模型和預測能力,揭示膠凝材料復合激發劑配比對充填體強度影響規律;最后,綜合極差分析和預測分析結果,獲得了利用燒結脫硫灰渣開發的全尾砂膠凝材料的最優配方。結果顯示:以鞍鋼全尾砂作為充填料,膠砂比為1∶6和濃度為70%的膠凝材料最優配比為:熟料4%,脫硫灰渣19%,芒硝0.5%,礦渣微粉76.5%,充填體28 d,強度最高達到3.883 MPa,是相同條件下水泥膠結充填體強度的1.7倍,但材料成本僅是水泥的40%~45%。
[Abstract]:Sintering desulphurization ash is the waste discharged from coking plant to produce steelmaking coke coal. Because desulphurization ash contains unstable mineral components such as free calcium oxide and calcium sulfite, it is difficult to utilize sintered desulphurization ash resources. Aiming at the mining of full tailings without waste filling method in Angang mine, the cementitious material of full tailings filling in Angang mine was developed by using slag powder and sintered desulphurization ash slag as the main materials and clinker and sulfate as composite activating agent. Firstly, the orthogonal test of the ratio of filling cementitious materials is carried out; then, on the basis of extreme difference analysis, the neural network model and prediction ability are established to reveal the influence of the ratio of composite exciter of cementitious materials on the strength of filling body. Finally, the optimal formula of the whole tailings cementitious material developed by sintering desulphurization ash is obtained by synthesizing the results of extreme difference analysis and prediction analysis. The results show that the optimum ratio of cement to sand is 4% clinker, 19% desulphurization slag, 0.5% mirabilite, 76.5% slag powder, 28 MPa, filling body and 3.883 MPa, but the material cost is only 40% and 45% of that of cement under the same conditions.
【作者單位】： 北京科技大學;鞍鋼集團礦山設計研究院;
【基金】：國家高技術研究發展計劃(863計劃)(SS2012AA062405)
【分類號】：TD853.343
[Abstract]:Sintering desulphurization ash is the waste discharged from coking plant to produce steelmaking coke coal. Because desulphurization ash contains unstable mineral components such as free calcium oxide and calcium sulfite, it is difficult to utilize sintered desulphurization ash resources. Aiming at the mining of full tailings without waste filling method in Angang mine, the cementitious material of full tailings filling in Angang mine was developed by using slag powder and sintered desulphurization ash slag as the main materials and clinker and sulfate as composite activating agent. Firstly, the orthogonal test of the ratio of filling cementitious materials is carried out; then, on the basis of extreme difference analysis, the neural network model and prediction ability are established to reveal the influence of the ratio of composite exciter of cementitious materials on the strength of filling body. Finally, the optimal formula of the whole tailings cementitious material developed by sintering desulphurization ash is obtained by synthesizing the results of extreme difference analysis and prediction analysis. The results show that the optimum ratio of cement to sand is 4% clinker, 19% desulphurization slag, 0.5% mirabilite, 76.5% slag powder, 28 MPa, filling body and 3.883 MPa, but the material cost is only 40% and 45% of that of cement under the same conditions.
【作者單位】： 北京科技大學;鞍鋼集團礦山設計研究院;
【基金】：國家高技術研究發展計劃(863計劃)(SS2012AA062405)
【分類號】：TD853.343
【相似文獻】
相關期刊論文 前10條
1 吳大敏;新型充填膠凝材料在新橋硫鐵礦試驗獲得成功[J];化工礦物與加工;2000年09期
2 屠麗南，王惠云，郭愛民，郭建明;改性氯氧鎂膠凝材料制品在煤礦的應用前景[J];建井技術;1995年01期
3 馮巨恩,郭生茂;粉煤灰作充填膠凝材料的應用研究[J];粉煤灰綜合利用;2001年05期
4 馬偉東;古德生;王R，
本文編號：2498102
本文鏈接：http://sikaile.net/kejilunwen/kuangye/2498102.html
最近更新
教材專著
