【摘要】：銅鉬礦的銅鉬分離一直是國內外銅鉬礦山的研究重點,銅鉬礦(主要是硫化礦)一般通過混合浮選得到銅鉬混合精礦,之后進行分離。絕大多數的礦山采用抑銅浮鉬來實現,烏山礦工業生產中也采用此工藝。烏山礦在銅鉬分離中通過添加有機和無機抑制劑配合使用來實現銅鉬有效分離,在工業生產中采用電位控制法,用Na HS調節氧化還原電位,可以使抑制劑8371達到良好的選擇性,穩定了鉬精礦的品位和含銅、鉬的作業回收率,在入選鉬品位由1.89%降低到1.65%的不利條件下,鉬精礦的鉬品位較試驗前47.52%提高到48.67%;鉬精礦中含銅由試驗前的1.46%降低到1.09%;鉬的回收率由試驗前的83.77%增加到87.35%,試驗取得了較好的效果。
[Abstract]:The separation of copper and Mo from copper-Mo ore has always been the focus of research at home and abroad. Copper-Mo ore (mainly sulfide ore) is generally obtained by mixed flotation, and then separated. Most of the mines are realized by inhibiting copper floating Mo, and this process is also used in the industrial production of Wushan Mine. In Wushan Mine, the effective separation of copper and Mo can be realized by adding organic and inorganic inhibitors in combination with each other. In industrial production, the redox potential can be adjusted by using potential control method and Na HS, so that the inhibitor 8371 can achieve good selectivity. The grade of Mo concentrate and the recovery rate of copper and Mo were stabilized. Under the unfavorable condition of decreasing the grade of Mo from 1.89% to 1.65%, the grade of Mo concentrate was increased to 48.67% compared with 47.52% before the test. The copper content in Mo concentrate decreased from 1.46% to 1.09%, and the recovery of Mo increased from 83.77% to 87.35%. Good results were obtained.
【作者單位】： 中國黃金集團內蒙古礦業有限公司;美國氰特公司;
【分類號】：TD95
，

本文編號：2486012