【摘要】：利用高階運動系數表示的通用加工參數用來進行弧齒錐齒輪的精確ease-off齒面反調修正。首先基于通用展成加工模型(UGM)采用高階多項式函數表達的通用加工參數來定義真實高階ease-off齒面。然后考慮到方程求解的強烈非線性引入敏感系數矩陣和改進的帶置信域策略的Levenberg-Marquardat(L-M)算法來獲得精確穩定的通用加工參數反調量。最后基于通用加工參數的高階反調方法被提出來主要包括:i)最優加工參數調整;ii)高階ease-off齒面修正。給出的算例證明高階反調修正后的齒面ease-off能夠達到1mm甚至更小提出的方法具有良好的實用性
[Abstract]:The general machining parameters expressed by high order motion coefficients are used to correct the accurate ease-off tooth surface of spiral bevel gears. Firstly, the real high-order ease-off tooth surface is defined by using the general machining parameters expressed by high-order multinomial function based on the general expansion machining model (UGM). Then, taking into account the strong nonlinear solution of the equation, the sensitivity coefficient matrix and the improved Levenberg-Marquardat (L 鈮，

本文編號：2499041