本文選題：慣量盤 + 脈動�。� 參考：《機床與液壓》2016年13期

【摘要】：在泵控馬達調速系統中,泵和馬達在工作時不斷的吸油和排油以及油液有可壓縮性等原因,使得系統流量產生脈動、壓力不穩定,所以馬達輸出軸轉速產生較大的波動,從而影響回轉工件的加工質量。通過在馬達軸安裝慣量盤,預在系統工作時使慣量盤吸收流量脈動,系統流量波動減小、壓力穩定性提高,馬達軸轉速波動降低。經過實驗驗證了該方法的可行性,說明在馬達輸出軸上加裝慣量盤能夠減小系統流量的脈動,使馬達軸轉速更加穩定。研究結論為在實際工況中解決流量脈動對馬達轉速的影響提供可靠方法。
[Abstract]:In the pump control motor speed regulation system, the pump and motor continuously absorb and drain oil while working, and the oil has compressibility, which causes the system flow rate to fluctuate and the pressure is unstable, so the speed of the motor output shaft is fluctuated greatly. Thus, the machining quality of the rotary workpiece is affected. By installing the inertia disk in the motor shaft, the inertia disk absorbs the flow pulsation while the system works, the system flow fluctuation decreases, the pressure stability increases, and the motor shaft speed fluctuation decreases. The feasibility of this method is verified by experiments. It is shown that adding inertia disk to the output shaft of the motor can reduce the pulsation of the system flow rate and make the rotation speed of the motor shaft more stable. The results provide a reliable method for solving the effect of flow pulsation on motor speed in actual working conditions.
【作者單位】： 長安大學工程機械學院;西安建筑科技大學機電工程學院;
【基金】：國家自然科學基金資助項目(51275375)
【分類號】：TH137.51
，

本文編號：1906301