熱鍍鋅沉沒輥裝置振動固有特性影響因素研究
發布時間:2018-03-23 03:21
本文選題:沉沒輥裝置 切入點:模態分析 出處:《機械科學與技術》2016年02期 論文類型:期刊論文
【摘要】:為研究沉沒輥裝置振動固有特性的影響因素,采用有限元技術,開展了沉沒輥裝置的濕模態和預應力模態分析,分別研究了流體密度、帶鋼斷面及其張力等因素對沉沒輥裝置振動頻率的影響程度及規律,并分析造成頻率差異的原因。結果表明:沉沒輥裝置在鋅液中振動時的頻率比在空氣中減小24.4%~58.8%,且頻率隨著流體密度的減小而增大;沉沒輥裝置在帶鋼斷面及其張力等預應力作用下的固有特性影響很小,但一些具有不對稱性的振型會減少軸承的工作壽命。
[Abstract]:In order to study the influence factors of vibration inherent characteristics of sunken roller device, the wet mode and prestressing mode analysis of sunken roller device were carried out by using finite element technique, and the fluid density was studied respectively. The influence degree and law of strip section and its tension on vibration frequency of sunken roller, The reason of frequency difference is analyzed. The results show that the frequency ratio of sinking-roller device in zinc liquid is reduced by 24.4% and 58.8% in air, and the frequency increases with the decrease of fluid density. The inherent characteristics of sunken roller device under the prestressing force such as strip section and tension have little influence, but some unsymmetrical vibration modes can reduce the working life of bearing.
【作者單位】: 武漢科技大學機械自動化學院;武漢鋼鐵股份有限公司冷軋總廠;
【基金】:國家自然科學基金項目(1251175387)資助
【分類號】:TH113.1;TG173
【相似文獻】
相關期刊論文 前1條
1 伍良生;陳長浩;侯濤;張震;;基于虛擬儀器技術結構固有特性的實驗測量[J];北京工業大學學報;2012年01期
,本文編號:1651673
本文鏈接:http://sikaile.net/kejilunwen/jixiegongcheng/1651673.html
最近更新
教材專著