本文關鍵詞：大型離心式壓縮機葉輪靜動載荷的分析與研究　出處：《東北大學》2013年碩士論文　論文類型：學位論文

  更多相關文章： 離心式壓縮機 葉輪 氣動載荷 流固耦合 非定常

【摘要】：隨著工業化的不斷加強,人類社會對氧氣、氮氣和氬氣等工業氣體的需求迅速增加,導致了空氣分離裝備的不斷大型化。而大型離心空氣壓縮機是大型空分氣離裝備的核心設備,其性能的好壞對整個空分裝備的安全可靠運行都至關重要。葉輪是離心壓縮機的關鍵部件,葉輪承受的載荷主要包括旋轉離心力、軸系振動力和氣動力。離心力會使葉片產生較大的靜應力,氣動力及軸系振動力將引起葉輪葉片的振動,從而使葉片產生較大的交變應力,導致葉輪葉片的疲勞破壞。因此,葉片靜動態載荷的確定成為葉輪設計的關健問題之一。本文依托973課題的研究背景,以制氧系統中的離心壓縮機為研究對象,借助CFD數值模擬技術研究了離心壓縮機葉輪的靜動態載荷�；趩蜗蛄鞴恬詈戏椒ǚ治隽藟嚎s機工作過程中的氣動載荷及離心載荷對葉輪模態參數的影響,以及空氣入口參數對葉輪氣動載荷的影響；并利用非定常流動理論,研究了葉片氣動載荷的瞬態特性。具體完成如下幾個內容。(1)利用CFX軟件對葉輪內部流場進行求解,并將計算的結果施加在葉輪表面,利用預應力模態分析法,研究了離心力和氣動載荷對葉輪模態參數的影響規律。結果表明,隨著階數的升高,預應力對模態頻率的影響變大,其中氣動載荷的影響較小。(2)通過調整理想氣體與理想水蒸氣的比例及改變進氣溫度,研究了空氣相對濕度及進氣溫度對葉輪表面氣動載荷的影響規律。分析結果表明,葉輪表面氣動載荷隨相對濕度的升高而增大,相對濕度每升高10%,氣動載荷增大200Pa左右；葉輪表面氣動載荷隨溫度的升高而升高,溫度每升高10℃,氣動載荷增大2000Pa左右。(3)對葉輪內部流場進行了非定常計算,得到了在靜止導葉下葉輪表面氣動載荷隨時間的變化規律,分析了導葉與葉輪之前的非定常干涉機理；分析了非諧設計導葉對葉輪內部非定常流動影響,揭示了非諧設計導葉對葉輪表面氣動載荷的影響規律；結果表明,氣體激振頻率與導葉個數和葉輪轉速有關而與進氣溫度無關；非諧設計導葉可以降低氣體的激振頻率,進而使頻率等于導葉個數與轉速乘積的激勵載荷的幅值減小,但同時使氣體低階激勵載荷的幅值增大。
[Abstract]:With the development of industrialization of human society to strengthen, oxygen, nitrogen and argon and other industrial gas demand increased rapidly, leading to a large scale air separation equipment. But the centrifugal air compressor is large large air separation gas from the core equipment, are vital to the safe and reliable operation of the performance of the whole equipment is divided into empty. The impeller is the key component of centrifugal compressor impeller, including load bearing rotating centrifugal force and aerodynamic force. The vibration of shafting, the centrifugal force will make the blade static stress is large, the aerodynamic and shafting vibration will cause the vibration of the impeller blades, and the blades generate high alternating stress, cause fatigue failure of the impeller blade the static and dynamic load. Therefore, the leaves determined to become one of the Guan Jian problem of impeller design. This paper based on the research background of the subject 973, the oxygen system of centrifugal compressor As the research object, by means of static and dynamic loads on the centrifugal compressor impeller CFD numerical simulation technology. The unidirectional flow solid coupling method of compressor working process of pneumatic impact load and centrifugal force on the impeller based on modal parameters, and air entrance parameters affect on dynamic load of impeller gas; and the use of non steady flow theory and transient characteristics of blade aerodynamic load. Complete the following content. (1) to solve the impeller internal flow by using the CFX software, and the calculation results were applied in the impeller surface, using the method of prestressed modal, influence of aerodynamic load on the modal parameters of the impeller of centrifugal force. The results showed that with the elevation of order, effect of prestress on the modal frequency of the larger, the smaller influence of aerodynamic load. (2) the proportion of adjustment and change of ideal gas and water vapor into the ideal Study on the gas temperature, air relative humidity and air temperature on the impeller surface aerodynamic effect of load. The analysis results show that the impeller surface aerodynamic load increases with the increase of relative humidity, relative humidity increases every 10%, the aerodynamic load increases about 200Pa; the surface of impeller aerodynamic load increases with the increase of temperature, temperature for every increase of 10 degrees, the aerodynamic load increases about 2000Pa. (3) the internal flow field of the impeller of the unsteady calculation, obtained in the static load variation with time by impeller surface gas leaves, analyzed before the guide vane and the impeller of the unsteady interference mechanism; analysis of non harmonic design guide leaves on the impeller internal unsteady flow effect, reveals the non harmonic design of vanes on the impeller surface aerodynamic effect of load; the results show that the gas excitation frequency and guide vanes and impeller speed without closing and the intake air temperature; non Harmonic design of guide vane can reduce the excitation frequency of gas, and then reduce the amplitude of the excitation load with the frequency equal to the number and speed of the guide vane, but at the same time, increase the amplitude of the low order excitation load of the gas.

【學位授予單位】：東北大學
【學位級別】：碩士
【學位授予年份】：2013
【分類號】：TH452

【參考文獻】

相關期刊論文 前10條

1 冀春俊;李彩華;惠洪杰;;葉片斷裂破壞與氣動非定常脈動的關聯分析[J];風機技術;2012年02期

2 張明明;侯安平;王強;;壓氣機進氣畸變誘導葉片振動數值研究[J];推進技術;2011年04期

3 張瑞琴;翁建生;;基于流固耦合的葉片顫振分析[J];計算機仿真;2011年03期

4 謝遠森;李意民;周忠寧;谷勇霞;;旋轉預應力條件下的葉片流固耦合模態分析[J];噪聲與振動控制;2009年04期

5 張環;胡駿;屠寶鋒;王志強;趙勇;;旋轉進氣畸變對壓氣機氣動穩定性及失速起始特性的影響[J];航空動力學報;2008年11期

6 李惠彬;周鸝麟;孫恬恬;王一棣;;渦輪增壓器葉輪流固耦合模態分析[J];振動、測試與診斷;2008年03期

7 周莉;席光;蔡元虎;;進口導葉/葉輪/擴壓器非定常相干的數值研究[J];西北工業大學學報;2007年05期

8 孟越;李琳;李其漢;;氣動非諧對葉片非定常氣動激振力影響[J];航空動力學報;2007年07期

9 郭術義,陳舉華;流固耦合應用研究進展[J];濟南大學學報(自然科學版);2004年02期

10 安柏濤,韓萬今,蘆文才,王仲奇;子午擴壓對環形葉柵流道內旋渦發生和發展的影響[J];航空動力學報;2000年04期

相關碩士學位論文 前2條

1 李輝;空氣分離過程中多機同步運行狀態參數變化規律的研究[D];東北大學;2012年

2 王楊;壓縮機首級旋轉失速的計算分析[D];大連理工大學;2008年

，

本文編號：1384859