基于單片機的電路信息實時采集系統設計
發布時間:2018-06-30 00:47
本文選題:STCC + 電路信息采集。 參考:《現代電子技術》2017年22期
【摘要】:為了提高電路信息實時采集的穩定性和可靠性,提出基于STC89C52單片機的電路信息實時采集系統設計方法。構造電路信息實時采集系統的總體結構模型,系統分為繼電器模塊、單片機控制模塊、A/D采樣電路模塊、輸出接口模塊等。采用UART循環堆?刂品椒ㄟM行信號采樣值幅度調整,對采集的實時信號通過放大濾波器輸出至A/D轉換器,采用單片機進行壓控放大控制,輸出高、低電壓至繼電器,實現實時采集信號的存儲和放大輸出。測試結果表明,信息實時采集系統具有較高的信號輸出放大增益,信號輸出的收斂性較好。
[Abstract]:In order to improve the stability and reliability of circuit information real-time acquisition, a design method of circuit information real-time acquisition system based on STC89C52 single chip microcomputer is presented. The overall structure model of the real-time circuit information acquisition system is constructed. The system is divided into relay module, MCU control module, A / D sampling circuit module, output interface module and so on. The UART cycle stack control method is used to adjust the amplitude of the signal sampling value. The real time signal is output to the A / D converter through amplifying filter, and the voltage control amplification control is carried out by single chip microcomputer, the output is high, low voltage to relay. The real-time acquisition signal can be stored and amplified. The test results show that the real-time information acquisition system has higher signal output amplification gain and better convergence of the signal output.
【作者單位】: 貴州師范學院物理與電子科學學院;貴州師范學院應用物理研究所;貴陽航空電機有限公司;
【基金】:國家自然科學基金(11647114)
【分類號】:TN70;TP368.12
【相似文獻】
相關期刊論文 前3條
1 陳雅琴,勾秋靜,皇甫麗英;面向?qū)W生,培養創新精神和實踐能力[J];高等工程教育研究;2004年06期
2 俞俊,沈海斌,嚴曉浪;CoCentric系統設計、仿真與實現[J];電路與系統學報;2004年06期
3 梁曉雯,裴小平,李玉虎;EDA系統設計的實驗教學構想[J];實驗技術與管理;2002年06期
相關碩士學位論文 前1條
1 孫騰坤;基于OR1200的SoC系統設計[D];貴州大學;2016年
,本文編號:2084109
本文鏈接:http://sikaile.net/kejilunwen/jisuanjikexuelunwen/2084109.html
最近更新
教材專著