研究經T6時效熱處理的模鍛態Al-5.87Zn-2.07Mg-2.42Cu合金從室溫升高到250℃時的高溫力學性能和顯微組織。高溫拉伸試驗結果表明,隨著拉伸溫度從室溫升高到250℃,合金的抗拉強度從638降至304 MPa,伸長率從13.6%升至20.4%。通過透射電子顯微鏡和電子背散射衍射技術對合金的顯微組織進行表征。研究發現,隨著拉伸溫度的升高,析出相發生粗化,位錯密度逐漸降低,合金組織發生不同程度的動態回復。在250℃進行拉伸時,合金內形成許多由小角度晶界組成的亞晶組織。 

【文章來源】：Transactions of Nonferrous Metals Society of China. 2020,30(07)EISCICSCD

【文章頁數】：9 頁

【文章目錄】：
1 Introduction
2 Experimental
3 Results
    3.1 Mechanical properties
    3.2 Fracture morphology
    3.3 Dislocation morphology
    3.4 Precipitates morphology
    3.5 Dynamic recovery behavior during high temperature tensile test
4 Discussion
    4.1 Precipitate states of alloy during high temperature tensile test
    4.2 Dynamic recovery of alloy during high temperature tensile test
    4.3 Effect of microstructure on mechanical properties
5 Conclusions


【參考文獻】：
期刊論文
[1]固溶-大變形-時效下7085鋁合金的強化機理[J]. 許曉靜,王子路,陸文俊,郭云飛,馬文海,陳洋,徐馳,張景玉.  稀有金屬材料與工程. 2017(04)



本文編號：3396750