【摘要】：采用X射線衍射、透射電鏡和力學性能測試等手段,系統研究了熱-機械處理對亞穩βTi-25Nb-2Mo-4Sn合金微觀組織和力學性能的影響。結果表明:由于合金中β穩定化元素含量不足,固溶處理后的合金中含有大量的α"馬氏體,合金呈現低屈服強度。經過相同的時效處理(400℃/2 h),固溶態和冷軋態樣品的相組成分別為β+ω和β+α相。冷變形引入的大量位錯和晶界可有效抑制時效過程中ω相的形成,并促進α相的析出。冷軋態樣品經475℃時效15 min后彈性模量為65 GPa,屈服強度和抗拉強度分別為1033和1113 MPa,實現了低模量和高強度的良好匹配。
[Abstract]:The effect of thermal-mechanical treatment on microstructure and mechanical properties of metastable 尾-Ti-25Nb-2Mo-4Sn alloy was systematically studied by means of X-ray diffraction, transmission electron microscopy and mechanical properties test. The results show that there is a large amount of 偽 "martensite in the alloy after solution treatment due to the insufficient content of 尾 stabilizing elements in the alloy, and the alloy exhibits low yield strength. After the same aging treatment (400 鈩，

本文編號：2447282