【摘要】：超重型切削過程中,刀具的高溫失效是硬質合金刀具破損的主要形式之一。首先,通過理論分析、切削仿真及數學模型進行切削熱產生過程分析,并研究切削溫度對硬質合金刀具變形抗力的影響;然后,進行切削溫度及材料高溫硬度測量實驗,實驗結果驗證模型有效,硬質合金和工件材料試塊的硬度在1000℃時分別下降了28%和60%左右;最后,從刀具幾何結構優化設計和復合涂層技術兩方面提出超重型切削專用硬質合金刀具抗高溫性能的提效措施,在5組切削參數下進行刀具壽命對比實驗,優化設計的XF8刀具壽命是YT15刀具的2~5倍。研究結果可以為重型高效切削刀具技術的研究及推廣提供借鑒。
[Abstract]:The high temperature failure of cutting tools is one of the main forms of carbide cutting tool breakage. Firstly, through theoretical analysis, cutting simulation and mathematical model, the process of cutting heat generation is analyzed, and the influence of cutting temperature on the deformation resistance of cemented carbide tools is studied. Then, the cutting temperature and the hardness of the material at high temperature are measured. The experimental results show that the model is effective. The hardness of the cemented carbide and the workpiece is decreased by about 28% and 60% at 1000 鈩，

本文編號：2314666