【摘要】：采用成組法對20Mn Ti B棒材進行疲勞試驗,將所得的數據點標在單對數坐標軸上,通過計算相關系數r可知:該組數據不滿足S-N曲線擬合的條件,即該組數據離散性較大�；贏BAQUS對失效的夾具螺紋進行有限元分析,并根據失效的螺紋牙部位及幾何形狀,對失效的螺紋牙進行受力分析,建立有限元模型。分析表明:夾具螺紋孔的偏心誤差使得夾具螺紋的局部螺紋牙承受較大應力是導致塑性變形的主要原因,從而證實了試驗所得數據離散性較大的原因,為今后的疲勞試驗夾具設計及保護提供了一定的經驗。
[Abstract]:The fatigue test of 20Mn Ti B bar was carried out by using group method. The data points were marked on the single logarithmic coordinate axis. By calculating the correlation coefficient r, it can be seen that the group data do not satisfy the condition of S-N curve fitting, that is, the group data is more discrete. Based on ABAQUS, the finite element analysis of the broken fixture thread is carried out, and the finite element model is established according to the position and geometry of the broken thread tooth. The analysis shows that the eccentricity error of the thread hole of the fixture causes the local thread teeth of the fixture thread to bear large stress, which is the main reason leading to plastic deformation, thus confirming the reason of the greater dispersion of the data obtained from the test. It provides some experience for the design and protection of fatigue test fixture in the future.
【作者單位】： 沈陽大學機械工程學院;中國船舶重工集團公司第七一二研究所;江蘇大學機械工程學院;
【基金】：國家高技術研究發展計劃(863)項目(2012AA040104)資助
【分類號】：TG75

【參考文獻】

相關期刊論文 前1條

1 史宏;劉金橋;謝國剛;;基于ABAQUS對螺栓斷裂問題仿真分析[J];佳木斯大學學報(自然科學版);2013年02期

相關碩士學位論文 前1條

1 林曉龍;高強度螺栓的應力分析及結構疲勞強度優化[D];東北大學;2012年

【共引文獻】

相關期刊論文 前1條

1 莫易敏;陳t，

本文編號：2225368