【摘要】：對某船用鈦合金固定軸球體進行解剖分析。采用掃描電鏡能譜儀、元素分析儀、顯微維氏硬度計、電子萬能材料試驗機和數顯沖擊試驗機分別對球體的成分(定性和定量)、硬度、力學性能和沖擊韌性進行分析測試,并對球體的顯微組織、拉伸和沖擊斷口形貌進行觀察。結果表明,該固定軸球體選用的鈦合金牌號為3M,橫向硬度約235 HV0.2,橫向抗拉強度約613MPa,橫向伸長率為11%,橫向斷面收縮率為31%,具有較好的沖擊韌性。球體的顯微組織由鋸齒狀α和片狀α相組成,拉伸斷口形貌表現為韌性剪切斷裂,沖擊斷口形貌為典型的韌窩。
[Abstract]:An anatomic analysis of a fixed shaft sphere of titanium alloy used in a ship was carried out. The composition (qualitative and quantitative), hardness, mechanical properties and impact toughness of the sphere were analyzed and tested by SEM, element analyzer, microhardness tester, electronic universal material tester and digital display impact tester, respectively. The microstructure, tensile and impact fracture morphology of the sphere were observed. The results show that the alloy grade is 3M, the transverse hardness is about 235HV0.2, the transverse tensile strength is about 613MPa, the transverse elongation is 11 and the transverse section shrinkage is 31. it has good impact toughness. The microstructure of the sphere is composed of zigzag 偽 and lamellar 偽 phase. The tensile fracture is characterized by ductile shear fracture and the impact fracture is a typical dimple.
【作者單位】： 寶鈦集團有限公司寶鈦研究院;
【分類號】：TG115

【相似文獻】

相關期刊論文 前6條

1 康文利;路世強;;UG在等高輪廓銑與固定軸輪廓銑中的綜合應用[J];機械工程師;2008年03期

2 金霞;楊曉京;;基于UG/CAM模塊固定軸曲面輪廓數控銑的研究[J];機床與液壓;2007年11期

3 鄧喜娟;;用靠模車球面裝置[J];機械工藝師;1988年08期

4 李英華;李志杰;;在車床上加工球面的裝置設計[J];考試周刊;2014年47期

5 ;多頭螺旋剁齒機[J];機床與工具;1959年04期

6 ;[J];;年期

，

本文編號：2160902