發布時間：2018-07-24 12:11

【摘要】：研究了鑄態690合金在不同初始組織條件下(細柱狀晶、粗柱狀晶和等軸枝晶)的熱壓縮流變曲線和變形組織,并對變形后樣品的微取向進行了分析,結果表明:在鑄態條件下,690合金的高溫流變抗力隨著變形溫度降低、應變速率升高和變形量增大而升高,在50%的壓縮量下,高溫(1200℃)和高速(1 s~(-1))有利于動態再結晶的發生。當壓縮方向垂直于柱狀晶方向時,二次枝晶滑動作為一種變形機制,導致應變速率敏感因子增大,此時細柱狀晶樣品變形抗力最小,再結晶比例最低,而初始組織為粗柱狀晶和等軸枝晶的樣品分別具有最大的變形抗力和最有利的動態再結晶條件。
[Abstract]:The hot compression rheological curves and deformed microstructure of as-cast 690 alloy under different initial microstructure (fine columnar, coarse columnar and equiaxed dendrite) were studied, and the microorientation of as-cast 690 alloy was analyzed. The results show that the high temperature rheological resistance of the alloy increases with the decrease of deformation temperature, the increase of strain rate and the increase of deformation amount. At 50% compression, high temperature (1200 鈩，

本文編號：2141341