本文選題：超細 + 硬質合金　； 參考：《稀有金屬材料與工程》2015年12期

【摘要】：采用正交實驗方法研究了注射溫度、注射壓力、注射速度、保壓壓力及其交互作用對超細WC-6Co硬質合金注射成形坯質量的影響。通過直觀分析和方差分析,比較了各因素影響注射坯質量的顯著程度,優化了注射成形參數。結果表明:注射溫度與注射壓力的交互作用、注射溫度與保壓壓力的交互作用、注射溫度和注射速度對注射坯密度的影響顯著;注射溫度與保壓壓力的交互作用、注射溫度與注射壓力的交互作用和注射速度對注射坯抗彎強度的影響顯著;臺階狀圓棒的最佳注射參數組合為注射溫度為100℃,注射壓力為60 MPa,注射速度為40%,保壓壓力為20 MPa。
[Abstract]:The effects of injection temperature, injection pressure, injection speed, pressure keeping pressure and their interaction on the quality of ultra-fine WC-6Co cemented carbide were studied by orthogonal experiment. By means of visual analysis and variance analysis, the influence of various factors on the quality of injection billet was compared, and the injection molding parameters were optimized. The results show that the interaction between injection temperature and injection pressure, the interaction between injection temperature and pressure, the effect of injection temperature and injection speed on the density of injection blank, the interaction between injection temperature and pressure, The interaction between injection temperature and injection pressure and injection speed have significant effects on the bending strength of injection billet, and the optimum injection parameters of step round rod are as follows: injection temperature is 100 鈩，

本文編號：2042675