本文選題：激光光譜 + 激光焊接��； 參考：《上海交通大學學報》2015年03期

【摘要】：首先從激光焊接鋁合金薄板的激光光譜入手,發現波長為600~650nm激光的光強幾乎不變,選擇了合適的窄帶寬濾光片,使得CCD相機采集的整個焊接過程圖片光強均一,整個過程不受焊接過程中激光光強的影響.然后在最佳的焊接參數下焊接,用2臺CCD相機在脈沖信號下同時進行圖像采集,通過匹配計算分析得到板件在整個焊接過程中全場三維變形量、形貌和應變,能夠?qū)崟r地再現變形過程,得到任意時刻的三維上的焊接變形量以及該時刻的形貌及應變.
[Abstract]:Starting with the laser spectrum of aluminum alloy sheet welded by laser, it is found that the light intensity of 600~650nm laser is almost invariable, and a suitable narrow band filter is selected, which makes the image of welding process collected by CCD camera uniform. The whole process is not affected by the laser intensity during the welding process. Then, under the best welding parameters, two CCD cameras are used to collect the image simultaneously under the pulse signal, and the 3D deformation, morphology and strain of the plate during the whole welding process are obtained by matching calculation and analysis. The deformation process can be reproduced in real time, and the welding deformation at any moment, the shape and strain of the moment can be obtained.
【作者單位】： 天津大學材料科學與工程學院天津市現代連接技術重點實驗室;
【基金】：國家自然科學基金項目(5097197,51275342)資助
【分類號】：TG404;TG456.7

【參考文獻】

相關期刊論文 前5條

1 陳忠;周曉峰;;非接觸數字圖像相關應變測量的仿真與實驗研究[J];測試技術學報;2012年02期

2 平萍;白泉;;焊接變形三維攝影測量技術的研究[J];大型鑄鍛件;2011年05期

3 李玲;;焊接變形光學測量技術研究[J];光學技術;2010年06期

4 何洪文;趙海燕;鈕文，

本文編號：2027518