本文選題：TiAl基合金 + 真空吸鑄�。� 參考：《航空材料學報》2015年02期

【摘要】：利用數值模擬和實驗相結合的方法,對金屬型底澆式真空吸鑄過程中合金熔體的射流寬度、反向充填位置和反向充填區域等流動狀態進行研究,并優化了工藝參數。研究表明,隨著吸口直徑尺寸增加,金屬液的射流寬度增大,反向充填位置從底部向上部移動,且充填區域也發生了相應的轉變,當吸口直徑為4mm時,射流寬度和型腔寬度一致,反向充填消失。當吸口直徑為4mm,澆注溫度為1620℃時,獲得了充型完整的TiAl基合金薄板件,鑄件鑄態組織晶粒細小,平均尺寸小于50μm,為全片層組織。
[Abstract]:By means of numerical simulation and experiment, the flow states such as jet width, reverse filling position and reverse filling area of alloy melt during the vacuum suction casting process of metal bottom casting were studied, and the process parameters were optimized. The results show that with the increase of suction diameter, the width of liquid metal jet increases, the reverse filling position moves from the bottom to the top, and the filling area changes accordingly. When the suction diameter is 4mm, The jet width is the same as the cavity width and the reverse filling disappears. When the suction diameter is 4 mm and the pouring temperature is 1620 鈩，

本文編號：1915525