本文選題：熔模精鑄　切入點：硅溶膠型殼　出處：《中國有色金屬學報》2015年11期 　論文類型：期刊論文

【摘要】：采用陶瓷和尼龍復合纖維增強熔模精鑄硅溶膠型殼,通過測試與分析復合纖維增強硅溶膠型殼的常溫及焙燒后強度和透氣性,研究復合纖維含量對硅溶膠型殼強度和透氣性的影響規律,確定復合纖維含量與焙燒溫度和型殼強度的關系,并通過SEM對型殼試樣斷口形貌進行觀察和分析。結果表明:復合纖維對硅溶膠型殼強度和透氣性的影響顯著,當復合纖維含量小于0.6%(質量分?jǐn)?shù))時,硅溶膠型殼強度和透氣性同時增大;當復合纖維含量大于0.6%時,型殼常溫及焙燒后強度開始減小,焙燒后基體中孔隙率增加,型殼透氣性繼續增大;當復合纖維含量為0.6%、焙燒溫度為1050℃時,型殼焙燒后強度達到最大值。
[Abstract]:Ceramic and nylon composite fiber reinforced investment casting silica sol shell was used. The strength and permeability of composite fiber reinforced silica sol shell at room temperature, roasting and air permeability were tested and analyzed. The influence of composite fiber content on the strength and permeability of silica sol shell was studied, and the relationship between composite fiber content and calcination temperature and shell strength was determined. The fracture morphology of the shell specimen was observed and analyzed by SEM. The results show that the composite fiber has a significant effect on the strength and permeability of the silica sol shell, and when the content of the composite fiber is less than 0.6 (mass fraction), The strength and permeability of silica sol shell increase at the same time, when the content of composite fiber is greater than 0.6, the strength of shell decreases at room temperature and after calcination, and the porosity in matrix increases and the permeability of shell increases after calcination. When the composite fiber content is 0.6 and the calcination temperature is 1050 鈩，

本文編號：1652079