本文選題：Sr變質　切入點：AlTiB細化　出處：《熱加工工藝》2015年22期 　論文類型：期刊論文

【摘要】：考察了Sr變質及固溶時效對鋁硅合金組織和性能的影響。結果表明,隨Sr量的增加,鋁硅合金中共晶硅的形貌由粗大的板片狀經過針片狀,最后轉變成了細小的纖維狀。當加入0.04%Sr變質時,合金抗拉強度達到最大值183 MPa;固溶時效處理使得經Sr變質及AlTiB細化處理的鋁合金中的共晶硅相發生了�；�,變成更加圓整的形態,并隨保溫時間延長而粗化。鑄造鋁硅合金經固溶時效處理后的硬度比鑄態有顯著提高。535℃×6h固溶+170℃×10h時效時,鋁硅合金的硬度值最高可達84.4 HBS。
[Abstract]:The effects of Sr modification and solution aging on the microstructure and properties of Al-Si alloy were investigated. When 0.04Sr was added, the tensile strength of the alloy reached the maximum 183MPa, and the eutectic silicon phase in the aluminum alloy refined by Sr and AlTiB was granulated by solution aging treatment. The hardness of cast aluminum-silicon alloy after solid solution aging treatment was significantly higher than that of as-cast Al-Si alloy, and the hardness of Al-Si alloy was up to 84.4 HBs when the alloy was aged at 170 鈩，

本文編號：1643035